Datacolor SpyderPRINT User manual

QUICK START GUIDE
What You Get
• Spyder®PRINT spectrocolorimeter
• Sensor Base
• SpyderGuide
• USB cord
• Serial Number
• Welcome Card – Including warranty information and download instructions
System Requirements
• USB port
•Windows 7 32/64, Windows 8.0, 8.1 32/64, 10 32/64
• Mac OS X 10.7 or higher
• Monitor Resolution 1280x768 or greater, 16-bit video card (24 recommended),
1GB of available RAM, 500MB of available hard disk space
• Internet connection for software download
Support
support.datacolor.com

Step 1 –Install and Activate
Install the SpyderPRINT Software from the Datacolor Website. After the
installation is complete, plug in your SpyderPRINT and launch the SpyderPRINT
software to begin the activation and registration process. This will automatically
start your warranty. Use the Serial Number included in your SpyderPRINT
package to activate your software.

Step 2 –Printer Settings
Change the settings for the printer you want to profile to:
Landscape orientation
0.25 in (.635 cm) margins
Single sided
Turn off any color management.

Step 3 –Print Target
Follow the on-screen instructions to specify the printer, paper type, and select the
target to be printed.
It is recommended to wait 15-30 minutes for the ink to dry before moving further.

Step 4 –Calibrate and Measure
Continue to follow the on-screen instructions to calibrate the SpyderPRINT. Then
begin to measure the printed target.

Step 5 –Apply Printer Profile
After the profile has been created, evaluated, and saved, remember to select this
profile in the printer dialog box of the application you are using to apply it to your
prints.
Datacolor, Spyder, SpyderPRINT and SpyderGUIDE are trademarks or registered
trademarks of Datacolor.
© Copyright 2015 Datacolor. All rights reserved.