Daytona 88263 User manual

Before installing, turn the adjustable knob
counter-clockwise to the end.
Fig.1
Softer
Place the FRONT FORK
BRACKET(#6) on the right
side over the triple tree.
Fig.2
15
70
8-10mm
Cut the plastic piece on the cover
side. To escape the contact of
the ROD END joint.
From bottom side In the location
of the height 70mm(2-3/4”) Width
15mm(9/16”) depth 8mm(5/16”).
Fig.3 #6
#7
#9
13mm
Fig.4
Distance between front
fork brackets and on the
triple tree fork stops are
approx. 13 mm(1/2”).
Triple tree upper side Fig.5
Be sure that the
lubricator is to be
faced inward.
F
W
D
Connect the DAMPER
BODY(#1) with a SPACER(#9).
Adjust the FRONT FORK
BRACKET(#6) position. Make sure
FRONT FORK BRACKET(#6) & DAMPER
BODY(#1) do not hit motorcycle frame neck
when turning the handle to the leftmost.
Fig.6
#1
#11
#9
BODY CLAMP(#13).
Install FRAME BRACKET(#2), FRAME CLAMP(#3) and
Fig.7
#3
#2
#12
#14
#13
#16
#4
#5
#10
#15
INSTRUCTION
1. Read all instructions before use.
2. After installation, check to see if all the parts are correctly
installed, and see if all the screws are torqued properly.
3. Do not adjust the damper while running.
4. Periodical inspection of the installed parts is required every
500km (300mile). If anything unusual may be found while
driving, pull over at a safe place to check.
Thank you for purchasing DAYTONA STEERING DAMPER KIT.
Product Features
- Stabilizes steering especially at high speed.
- Prevents the front forks from being twisted at high speed
cornering.
- The kit comes with complete bracket kit for easy mounting.
Must be cut down a little plastic fork cover.
Install
88263 / 180605
1
STEERING DAMPER KIT
for Harley Davidson FLT 2009-2013

88263 / 180605
2
#14 #2
#15
#13
#16 #8
#12
Fig.8
25mm
(1.0”)
Adjust the DAMPER
BODY(#1) position. Make
sure DAMPER BODY(#1)
doesn’t hit any part of
motorcycle when turning
the handle to the leftmost
and rightmost.
Fig.9
Softer Harder
How to ast the damping force
Turn the adjustable knob
clockwise → Harder
Turn the adjustable knob
counter-clockwise → Softer
Fig.10
12. M8 FLANGE NUT
[ 22N-m / 16lbf-ft ]
15. M8x35
BUTTON HEAD
SCREW
14. ROD END
4. M8x50 FLANGE BOLT
(CAP SCREW)
[ 22N-m / 16lbf-ft ]
16. M8 NUT
[ 22N-m / 16lbf-ft ]
13. BODY CLAMP
9. SPACER
1. DAMPER BODY
7. M6 CAP SCREW
[ 10N-m / 7lbf-ft ]
6月. FRONT FORK
BRACKET
8. TEFRON WASHER
11. M8x35 CAP SCREW
[ 22N-m / 16lbf-ft ]
10. WASHER
5. M8x50 FLANGE BOLT
(CAP SCREW)
[ 22N-m / 16lbf-ft ]
2. FRAME
BRACKET
3. FRAME
CLAMP
FOR NON FAIRING MODEL