DECKED ToolBox Ladder Bracket User manual

DECKED.COM |#DECKEDUSA |@DECKEDUSA RC618| v.3| Page 2
@DECKEDUSA | #DECKEDUSA
FOLLOW US:
LADDER INSTALLATION TOOLS NEEDED:
•5/32”hexwrench
•Check to see that the ladder pivot brackets are installed - (orange in Detail A). If not, see previous page.
•Rest thefolded ladder ona table orhard surface sothat you canread the instructionson the bottomof the firstrung.
•Whileholding the toprung, pull thebottom rung fromthe ladder assemblyuntil both thebottom and middlerungs lock inplace.
• Settheladder ontheground verticallynexttothe passengersideofyourToolBox.
• Raisebotharms andextendthemupand overthe edgeofthe ToolBoxto meet with themounting discs. NOTE: The ladder brackets must be facing down.
• Usinga 5/32” hexwrench,installthehardwareintheordershown,DETAILA.Repeaton oppositeside.Tightenuntilsnug - DO NOT OVERTIGHTEN.
• Returntheladder totheToolBoxbycollapsing the rungsand folding back intoplace.
➡
CAB
A
DETAIL A
LADDER
BRACKET
“CLICK”
STEP 1
▼ WARNING DON’T DO THIS ▼
“CLICK” AGAIN
STEP 2 STEP 3
USING THE LADDER:
WATCHLADDERINSTRUCTIONALVIDEOS:
DECKED.COM/LADDER
PLACE LADDER ON SOLID GROUND
WITH BOTH RUNGS LOCKED INTO
PLACE (LADDER STEPS 1-3). FAILURE
TO DO THIS COULD ALLOW LADDER
TO SWING INTO TRUCK AND CAUSE
DAMAGE TO THE VEHICLE
POSITION LADDER
VERTICALLY TO
SOLID GROUND