Dell OptiPlex 3080 Tower User manual

Dell OptiPlex 3080 Tower Cable Cover
User Guide
October 2020
Rev. A00

Notes, cautions, and warnings
NOTE: A NOTE indicates important information that helps you make better use of your product.
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid
the problem.
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
© 2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other
trademarks may be trademarks of their respective owners.

Chapter 1: Dell OptiPlex Tower Cable Cover.................................................................................. 4
Chapter 2: Getting help.................................................................................................................8
Contacting Dell.....................................................................................................................................................................8
Contents
Contents 3

Dell OptiPlex Tower Cable Cover
The cable cover for the Dell OptiPlex Tower system helps protect the ports and cables that are connected to the system.
About this task
Follow these steps to install the cable cover.
NOTE: Images that are shown below may vary depending on your system configuration.
Steps
1. Route the cables through the slot at the bottom of the cable cover.
2. Draw out the cables from the other side of the cable cover.
3. Connect the cables to their respective ports and turn the antenna (if available/applicable) outwards to pass through the
antenna slot at the top of the cable cover.
1
4 Dell OptiPlex Tower Cable Cover

4. Align the cable cover retaining hooks into their slots on the Dell OptiPlex Tower chassis.
CAUTION: Take care not to bend or break the delicate plastic hooks.
Dell OptiPlex Tower Cable Cover 5