Dell OptiPlex 3080 Tower User manual

Dell OptiPlex 3080 Tower Dust Filter
User Guide
October 2020
Rev. A00

Notes, cautions, and warnings
NOTE: A NOTE indicates important information that helps you make better use of your product.
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid
the problem.
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
© 2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other
trademarks may be trademarks of their respective owners.

Chapter 1: Dust Filter for OptiPlex Tower...................................................................................... 4
Chapter 2: Getting help.................................................................................................................6
Contacting Dell.....................................................................................................................................................................6
Contents
Contents 3

Dust Filter for OptiPlex Tower
The dust filter for the Dell OptiPlex Tower helps protect the system from fine dust particles. After installation, the BIOS can be
enabled to generate a preboot reminder to clean or replace the dust filter based on the time interval set.
About this task
Follow these steps to install the dust filter:
Steps
1. Align the top edge of the dust filter to the top edge of the system.
2. Press the lower edge of the dust filter to close over the system.
3. Gently press as shown to ensure that the filter fits snugly onto the system.
1
4 Dust Filter for OptiPlex Tower

NOTE: Dust filter design may vary.
4. Restart the system and press F2 to enter the BIOS Setup menu.
5. In the BIOS Setup menu, go to System Configuration > Dust Filter Maintenance and select from any of the following
intervals: 15, 30, 60, 90, 120, 150, or 180 days.
NOTE: Default setting: Disabled.
NOTE: Alerts are generated only during a system reboot and not during normal operating system operation.
Next steps
To clean the dust filter, brush or gently vacuum and then wipe down the external surfaces with a moist cloth.
Dust Filter for OptiPlex Tower 5