Dell PowerVault 200S Quick guide

(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\Hendrix\Ts\standalone\5920Pam0.fm
DELL CONFIDENTIAL - PRELIMINARY 2/15/99 ™
P/N 5920P December 1998
&
www.dell.com
,QVWDOOLQJWKH'HOO3RZHU9DXOW
[66WDELOL]HUVIRU6WDQGDORQH
&RQILJXUDWLRQ
Perform the following steps to attach the stabilizers to the chassis, which converts a
Dell PowerVault 20
x S storage system to a free-standing, vertical configuration:
1. Carefully turn the chassis upside down.
2. Locate the two pairs of screw holes on the bottom panel.
3. Align one of the stabilizers with one pair of screw holes, and then align the other
stabilizer with the other pair of screw holes, as shown in Figure 1.
)LJXUH$WWDFKLQJWKH6WDELOL]HUV
stabilizers (2) bottom of chassis

(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\Hendrix\Ts\standalone\5920Pam0.fm
DELL CONFIDENTIAL - PRELIMINARY 2/15/99
4. Use the four screws that came with your kit to secure the stabilizers to the bot-
tom of the chassis.
5. Carefully turn the chassis over, so the stabilizers are at the bottom.
____________________
Information in this document is subject to change without notice.
© 1998 Dell Computer Corporation. All rights reserved. Printed in the U.S.A.
Trademarks used in this text:
Dell
, the
DELL
logo, and
PowerVault
are trademarks of Dell Com-
puter Corporation. Other trademarks and trade names may be used in this document to refer to
either the entities claiming the marks and names or their products. Dell Computer Corporation
disclaims any proprietary interest in trademarks and trade names other than its own.