DeLonghi HFX30 Series User manual

RADIATEUR SOUFFLANT CÉRAMIQUE
Mode d’emploi . Conservez cette notice
Visitez www.delonghi.com pour y voir une liste des centres de répara-
tion proches de chez vous.
CARACTÉRISTIQUES ÉLECTRIQUES
120 V~ 60 Hz1500 W
INSTANT CERAMIC HEATER
Instructions for use. Keep these instructions
Visit www.delonghi.com for a list of service centers near you.
ELECTRIC CHARACTERISTICS
120 V~ 60 Hz1500 W
HFX30 Series

2
3
A
C
B
E
D

www.delonghi.com 5711413221_01_0517 Printed in China

9
IMPORTANT
SAFEGUARDS
When using any electrical appliance, some basic safety
precautions should always be observed to reduce the
risk of re, electric shock, and/or injury to persons. Read
all instructions carefully before using the appliance.
Specically:
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- The appliance must not be placed
immediately under a xed power
socket.
- Do not use the appliance outdoors.
- Do not operate any heater with
a damaged cord or plug or after
the heater malfunctions, has
been dropped or damaged in
any manner. Return heater
to authorized service facility
for examination, electrical or
mechanical adjustment, or
repair.
- This heater is not intended for use in
bathrooms, laundry areas and similar
indoor locations. Never locate heater
where it may fall into a bath tub or
other water container.
- If the power cable is damaged, stop
using the product. Power cable must
be replaced by the manufacturer, an
authorisedservicecentreoraqualied
electrician in order to eliminate all
risk.
- Do not use this heater in the
immediate surroundings of a bath, a
shower and sinks or a swimming pool.
- Do not insert or allow foreign objects
to enter any ventilation or exhaust
opening as this may cause an electric
shock, re, or damage the heater.
- CAUTION: to prevent electric
shock match wide blade of plug
to wide slot, then fully insert.
- CAUTION: In order to avoid a hazard
due to inadvertent resetting of
thermal cutout, this appliance must
not be supplied through an external
switching device, such as a timer, or
connected to a circuit that is regulary
switched on and o by the utility.
- If you intend to x your appliance to
the wall, make sure that the switch or
other control devices are not within
reachofpersons in thebathorshower.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
-The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
- CAUTION — Some parts of this
product can become very hot and
cause burns.
- Extreme caution is necessary when
any heater is used by or near children
and whenever the heater is left
operating and unattended.
- Always disconnect the plug from the
power outlet when the appliance is

10
not in use.
- Do not wrap the cord around the ap-
pliance immediately after use.
- Theinternalpartsof the appliance can
become very hot or produce sparks
during operation. Do not use the
appliance in areas where gasoline,
paints, or other ammable liquids are
used or stored.
- Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause re, electric shock, or
injury to persons.
- To prevent overload and blown fuses,
be sure that no other appliance
is plugged into the same outlet
(receptacle) or into another outlet
(receptacle) wired into the same
circuit.
- Make sure that the plug is fully
inserted into the outlet.
Wall outlets may deteriorate with
time,sochecktheplugperiodicallyfor
signs of overheating or deformation.
If the outlet has deteriorated, stop
using it and have it repaired.
- Do not use the appliance in small
rooms when they are occupied by
persons that are not capable of
leaving the room, unless constant
supervision is provided.
Danger of burns!!
Failure to observe the warning could result in burns or
scalds.
- WARNING: To avoid
overheating, never under
any circumstances cover the
appliance during operation as this
would lead to a dangerous rise in
temperature, and risk of re.
- Do not use the appliance on soft
surfaces, such as beds, where the
openings may become blocked.
- This heater is hot when in use. To
prevent burns, do not let bare skin
touch hot surfaces. Use handle when
moving this heater. To prevent burns,
do not touch hot surfaces with bare
skin. Use the handle when moving
the appliance. Keep all ammable
materials, such as furniture, pillows,
bedding, paper, clothing, and curtains
at least 90 cm (3 feet) from the front
and top of the appliance also avoid
contact with the sides and back.
- Do not run cord under carpeting.
Do not cover cord with throw rugs,
runners, or the like. Arrange cord
away from trac area and where it
will not be tripped over.
- It is normal for the heater’s plug and
cord to feel warm to the touch. A plug
or cord which becomes hot tothe
touch or becomes distorted in shape
may be a result of a worn electrical
outlet. Worn outlets or receptacles
should be replaced prior to further use
of the heater. Plugging heater into a
worn outlet /receptacle/ may result in
overheating of the power cord or re.
- WARNING: Do not cover the appliance
while it is functioning in order to
avoid overheating which may cause
risk of re.
Symbol meaning
This simbol indicates:
(If provided) Class II equipment

11
Please note:
This symbol indicates recommendations and important
information for the user.
-If your appliance is equipped with a
polythene tape used as carry handle,
removeitbeforeconnectingappliance
to the outlet.
- Alwaysusetheapplianceinanupright
position.
- To disconnect heater, turn controls to
o, then remove plug from outlet.
- Connect to properly polarized outlets
only.
- This heater is not intended for use
with an extension cord or outlet
strip. Plug the cord directly into an
appropriate wall receptable.
- Check that neither the appliance nor
the power cable have been damaged
in any way during transportation.
- Makesurethatnopiecesofpolystyrene
or other packaging material have
been left on the appliance. It may be
necessary to pass over the appliance
with a vacuum cleaner.
- When switching on the appliance for
the rst time, allow it to run at full
power for at least two hours to get
rid of the unpleasant smell. Make sure
that the room in which the appliance
is located is well ventilated during
this operation. It is normal for the
appliance to emit small cracking
sounds when you turn it on.
- Do not use the appliance in rooms
with a oor area of less than 4mq (43
square feet).
- Before putting the appliance away,
make sure it is completely o and
unplugged from the mains socket.
Wrap the cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not place the heater near a bed
because objects such as pillows or
blankets can fall o the bed and be
ignited by the heater.
- (Certain models only) A tip over safety
device turns the appliance o if it falls
over or is positioned inappropriately
in such a way as to jeopardise safety.
The appliance resumes operation
a few seconds after being placed
in an upright position again. See
troubleshooting session.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A Thermostat
B Function selector
C Indicator light
DTip over switch (certain models only)
E Foldable support
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
- Before plugging into the outlet, make sure the voltage
of your power supply corresponds to the value V indica-
ted on the appliance and that the socket and power line
are appropriate for the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/

12
EC ON ELECTROMAGNETIC COMPATIBILITY.
Functioning and use
Please note: pull out the support outwards by placing
ngers in the slot (see gure on page 3). If the support isn’t
pulled out, the product will not stand up and fall down.
Always operate the heater in upright position only.
Any other position could create a hazardous situation.
1. Plug the appliance into the outlet.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the position (the indicator light will go on).
4. Low power operation: turn the function selector to posi-
tion 1(the indicator light will go on).
5. High power operation: turn the function selector to po-
sition 2(the indicator light will go on).
6. Switching o: turn the function selector to the“0”posi-
tion (the indicator light will go o).
Setting the thermostat
Position the thermostat on maximum.
When the room has reached the required temperature, turn
the thermostat dial slowly counterclockwise until you hear a
click and the fan goes o (the indicator light stays on). The
thermostat will then keep room temperature at the selected
level automatically.
Frost prevention mode
With the function selector in position 2and the thermostat
dial in position , the appliance maintains room tempera-
ture at about
5°C (41°F) , preventing freezing with minimal
energy consumption (the indicator light will stay on).
MAINTENANCE
- Always unplug from the outlet before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the
appliance.
SAFETY FUNCTIONS
-Safety device: the appliance is tted with a safety
device that switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug in
again. If the appliance doesn’t work please contact the
De’Longhi Customer Service.
- Tip-over safety device: certain models are tted
with a tip-over switch (D) which turns the appliance o
if it falls over. To restart the appliance, simply place it
upright again.
PROBLEM CAUSE SOLUTION
The appliance doesn’t work Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The function selector is in the ”0” po-
sition.
The thermostat may be set too low.
Plug into the outlet.
Remove the obstruction, unplug the
heater and let the appliance cool down.
If the appliance doesn't work please
contact the De longhi toll free number.
Turn the function selector to the position
or“1”or ”2”.
Turn the thermostat clockwise to a higher
setting until the heater restarts.
The tip-over switch has been activated
(certain models only).
Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you.
TROUBLESHOOTING