DeLonghi TRD40615T-6A User manual

TRD40615T-6A
ELECTRIC OIL FILLED RADIATOR
Instructions for use. Keep these instructions
Visit www.delonghi.com for a list of service centers near you.
ELECTRIC CHARACTERISTICS
120 V~ 60 Hz1500 W
RADIADOR ELÉCTRICO DE BAÑO DE ACEITE
Repase y guarde estas instrucciones.
Lea cuidadosamente este instructivo antes de usar su aparato.
Visite www.delonghi.com para ver la lista de centros de servicios cercanos a usted.
CARACTERISTICAS ELECTRICAS:
120 V~ 60 Hz1500 W

2
EN ES
page 4 pág. 8

3
A
B
C
H
G
E
F
D

4
IMPORTANT
SAFEGUARDS
When using any electrical appliance, some basic safety pre-
cautions should always be observed to reduce the risk of re,
electric shock, and/or injury to persons. Read all instructions
carefully before using the appliance. Specically:
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- Do not operate any appliance with a damaged
cord or plug or after the appliance malfun-
ctions, has been dropped or damaged in any
manner.
If appliance has leaked any oil, discontinue
using the appliance and contact the service
centre as indicated in the instruction leaet.
Return appliance to authorized service facili-
ty for examination, electrical or mechanical
adjustment, or repair.
- This appliance is not intended for use in
bathrooms, laundry areas, or similar indoor
locations. Never position the appliance where
it may fall into a bathtub or come in contact
with water.
- Use this appliance only as described in this
manual. Any other use not indicated by the
manufacturer may cause re, electric shock,
or injury to persons.
- CAUTION:To prevent electric shock, make sure
the wide prong of the plug is inserted in the
wide slot of the outlet.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
- The appliance is not intended for use by per-
sons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concer-
ning use of the appliance by a person respon-
sible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
- Extreme caution is necessary when any ap-
pliance is used by or near children or invalids
and whenever the appliance is left operating
and unattended.
- Do not wrap the cord around the appliance
immediately after use.
- To prevent current overload and blown fuses,
make sure that no other appliance is plugged
into the same outlet or into another outlet
wired into the same circuit.
- If the power cord is damaged, to reduce the
risk of malfunction it must be replaced by the
manufacturer, its service agent, or a licensed
and qualied professional.
- Do not use this appliance with an extension
cord or outlet strip. Connect the appliance di-
rectly to a suitable outlet.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- This appliance gets very hot when in use. To
prevent burns, do not touch hot surfaces with
bare skin. Use the handle when moving the
appliance. Keep all ammable materials, such
asfurniture,pillows,bedding,paper, clothing,
and curtains at least 3 feet (90 cm) from the
front and top of the appliance, also avoid con-
tact with the sides and back.
- Do not run the power cord under carpeting.
Do not cover cord with throw rugs, runners, or
the like. Keep the cord away from any passa-
geways where it could be tripped over.
- Do not insert or allow foreign objects to get
into the air intake or air outlet grille, as this
may cause electric shock or re, or damage
the appliance.
- To prevent a possible re, do not block air in-
take or air outlet grille in any way. Do not use
the appliance on soft surfaces, such as beds,
where the openings may become blocked.
- Do not cover the appliance while it is functio-
ning in order to avoid overheating and the risk
of re.
- The internal parts of the appliance can beco-

5
Fig. 1
me very hot or produce sparks during opera-
tion. Do not use the appliance in areas where
gasoline, paints, or other ammable liquids
are used or stored.
- It is normal for appliance’s plug and cord to
feel warm to the touch. However, an exces-
sively hot or deformed plug or cord is not
normal and may be the result of a defective
electrical outlet. Defective outlets must be
replaced before using the appliance. Plugging
the appliance into a worn outlet may result in
overheating of the power cord or may cause
the risk of re.
- Do notplacethe applianceneara bed because
objects such as pillows or blankets can fall o
the bed and be ignited by the appliance.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a
polyethylene tape used as a carry handle,
remove it before connecting appliance to the
outlet.
- Always disconnect the plug from the power
outlet when the appliance is not in use.
- Do not use the appliance outdoors.
- To completely shut the appliance o, turn the
power selector to the "0" position and then
unplug the appliance from the outlet.
- Connect to properly polarized outlets only.
- Make sure that the plug is fully inserted into
the outlet. Wall outlets may deteriorate with
time, so check the plug periodically for signs
of overheating or deformation. If the outlet
has deteriorated, stop using it and have it re-
paired.
- Check that neither the appliance nor the po-
wer cord have been damaged during ship-
ping.
- Make sure that no styrofoam or other packing
materials remain in the appliance.
- Make sure that no pieces of polystyrene or
other packaging material have been left
between one element of the appliance and
another. It may be necessary to pass over the
appliance with a vacuum cleaner.
- The rst time the appliance is used, run it at
the maximum power for at least two hours.
During this time, ventilate the room thorou-
ghly to eliminate the“new”smell released by
the appliance. It is completely normal for the
appliance to emit “creaking” sounds the rst
time it is run.
- Extreme caution is necessary whenever the
appliance is left operating unattended.
- Do not open the appliance. No user-servicea-
ble parts inside.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A Thermostat
B Power setting knob
C/D/E Power indicator lights (MIN, MED, MAX)
F Timer
G Cord holder
H Wheel
USE
Fitting the wheels
Turn the appliance upside down on a rug or soft surface to
prevent damaging the paint nish. Fully unfold the wheels
by turning them outwards (Fig. 1). Turn the appliance back
to its upright position.
Important! Always operate the appliance in upright
position only (wheels on the bottom, controls on top). Any
other position could create hazardous situation.

6
Location
Place appliance on the oor beneath the coldest window
in the room, or any other location. Your appliance will re-
duce the eect of cold drafts. The appliance should not be
placed immediately below a power outlet. Do not use this
appliance in rooms with a oor area of less than 43 square
feet (4 sq. m.).
Connection
The appliance should be connected to a properly polarized
household outlet in perfect working condition. Keep loose
clothing or bedding, furniture and ammable material away
from the appliance’s wall outlet.
Turning on
Insert the plug into an electrical outlet, turn the thermostat
knob clockwise to maximum and turn the unit on as follows
using the power selector:
- Turn the power selector to position MIN to select
minimum output (the min light will be on).
- Turn the power selector to position MED to select
medium output (the min/med light will be on).
- Turn the power selector to position MAX to select
maximum output (the lights will be on).
Adjusting the thermostat
When the room has reached the desired temperature,
turn the thermostat knob slowly in an counter-clockwise
direction until you hear a "click" and not beyond it.
The thermostat will then adjust the set temperature
automatically and keep it constant. If your unit is a three-
output version, in intermediate seasons or on days when
temperatures are not particularly cold, select minimum
output to optimize savings and consumption.
Use of thermostat
The thermostat operates according to room air temperature,
rather than appliance temperature.
Turning it counter-clockwise to smaller numbers would
decrease the temperature; clockwise to greater numbers
would increase the temperature.
Antifreeze function
Turn the thermostat knob to the position and the power
selector to position MAX. The appliance will maintain a
minimum room temperature of approximately 41°F (5°C),
this preventing freezing while conserving energy. In models
that come with a timer, tabs must be set in the inward
position.
Please note:To completely shut the appliance o, turn
the power selector to the "0" position and then unplug the
appliance from the outlet.
UNITS WITH TIMER
Clock setting
The program/timer, as with all clocks, must be set to the
correct time. If for example the time is 9:30 a.m. (day zone),
turnthe knob clockwise (followingthe direction ofthearrow)
until 9:30 is aligned with the triangular pointer.
IMPORTANT: DO NOT TURN CLOCK KNOB COUNTER-
CLOCKWISE.
The timer is like an electric clock, and will only work when
plugged into a power supply. When unplugged, the timer
stops and must be later re-set.
How to use the timer
To program heating, proceed as follows:
- Set the periods of time when you want the appliance
to work by pushing the teeth (1) inward. Each tooth
(1) corresponds to a period of 15 minutes. This will
leave visible sectors which correspond to the periods
of operation (2). When set, the appliance will operate
automatically each day during the times programmed
(important: the appliance must always be plugged into
Your product is equipped with a polarized alternating
current line plug (a plug having one prong wider than the
others). This plug will t into the power outlet only one
way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug. If the plug
should still fail to t, contact your electrician to replace
your obsolete outlet. Do not attempt to modify the plug to
bypass this safety feature.

7
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The temperature may be set too low.
Plug into the power outlet.
Remove the obstruction and let the
appliance cool down. If the appliance
doesn't work please contact the De longhi
toll free number.
Set the temperature to a higher position.
the socket).
- To change the programming, move the teeth back into
the initial position and set the new periods of operation.
- If you want to make the appliance operate without
programming, push all the teeth inward. In this case, to
turn the appliance o completely, as well as turning the
knob to the "0" position, you must also unplug it from
the power outlet to avoid continued operation of the
timer.
SAFETY DEVICE
A safety device switches the appliance o in the event of
overheating.To restart the appliance, contact the De longhi
toll free number.
MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the
appliance to cool. Wipe appliance with a soft damp cloth, do
not use detergents and abrasives.
Should the appliance not be in use over a certain length of
time, wrap the cord around the cord holder and store it in a
dry place.
This appliance has been built to give many years of trouble
free service. In case of malfunction or doubt, do not try to
repair the appliance by yourself: this may result in a re
hazard or electric shock. Contact the De longhi toll free
number.