Delta Amplon RT Series User manual

www.deltapowersolutions.com
Delta UPS - Amplon Family
The power behind competitiveness
User Manual
RT Series, Single Phase
1/ 1.5/ 2/ 3 kVA
External Battery Pack

Amplon RT Series I
Save This Manual
Copyright © 2019 by Delta Electronics Inc. All Rights Reserved. All rights of this User
Manual (“Manual”), including but not limited to the contents, information, and figures
are solely owned and reserved by Delta Electronics Inc. (“Delta”). The Manual can
only be applied to the operation or the use of this product. Any disposition,
duplication, dissemination, reproduction, modification, translation, extraction, or
usage of this Manual in whole or in part is prohibited without the prior written
permission of Delta. Given that Delta will continuously improve and develop the
product, changes may be made to the information in this Manual at any time without
obligation to notify any person of such revision or changes. Delta will make all
possible efforts to secure the accuracy and the integrity of this Manual. Delta
disclaims any kinds or forms of warranty, guarantee, or undertaking, either expressly
or implicitly, including but not limited to the completeness, faultlessness, accuracy,
non-infringement, merchantability or fitness for a particular purpose of the Manual.
This manual contains important instructions and warnings that you should follow
during the installation, operation, storage and maintenance of this product.
Failure to heed these instructions and warnings will void the warranty.

Table of Contents
II
Table of Contents
Chapter 1 : Product Introduction ........................................................ 1
Chapter 2 : Important Safety Instructions .......................................... 2
Chapter 3 : Package List ...................................................................... 4
Chapter 4 : Installation Procedures .................................................... 6
Chapter 5 : Operation Procedures .................................................... 12
Chapter 6 : Technical Specifications ................................................ 13

Amplon RT Series 1
Chapter 1 : Product Introduction
When the UPS is operating during a power outage, the battery pack provides DC
power, which maintains inverter operation to supply power to the critical loads
connected to the UPS.
(Figure 1: Delta External Battery Pack Front View)

Chapter 2 : Important Safety Instructions
2
Chapter 2 : Important Safety Instructions
 Servicing of batteries and battery packs must be performed or supervised by
qualified service personnel knowledgeable in batteries, battery packs and the
required precautions. Keep unauthorized personnel away from batteries and
battery packs.
 A battery can present a risk of electric shock and high short-circuit current.
 To reduce the risk of fire or electric shock, install the battery pack in a
temperature and humidity controlled indoor area free of conductive
contaminants.
 Forbid opening or removing the cover of the battery pack to avoid high voltage
electric shock.
 The risk of dangerous high voltage is possible when the batteries are still
connected to the UPS even though the UPS is disconnected from the mains.
Do not forget to disconnect the battery cable to completely cut off the battery
source.
 Turn off the UPS and cut off the AC source before performing battery/ battery
pack replacement.
 Only use the same type of batteries from the same supplier. Never use old,
new and different Ah batteries at the same time.
 The number of batteries must meet UPS requirements.
 Do not reverse or short circuit the polarity + and – when connecting the
batteries because this will destroy the device and constitute a risk of electric
shock or fire.

Amplon RT Series 3
 Use a voltage meter to measure whether the total voltage, after battery pack
connection, is around 12.5Vdc × the total number of batteries.
 The external slits and openings of the battery pack are provided for ventilation.
To ensure reliable operation of the battery pack and to protect the battery pack
from overheating, these slits and openings must not be blocked or covered.
 Do not insert any object into the slits and openings that may hinder ventilation.
 Do not allow liquid or any foreign object to enter the battery pack.
 Do not place beverages or any other liquid-containing vessels on or near the
battery pack.
 Do not dispose of the battery or batteries in a fire. The batteries may explode.
 Do not open or mutilate the battery or batteries. The released electrolyte is
harmful to the skin and eyes and may be toxic.
 Observe the following before replacing batteries:
1. Remove watches, rings, or other metal objects.
2. Use tools with insulated handles.
3. Wear rubber gloves and boots.
4. Do not lay tools or metal parts on the top of batteries.
5. Disconnect the charging source prior to connecting or disconnecting the
batteries’ terminals.

Chapter 3 : Package List
4
Chapter 3 : Package List
No. ITEM Q’ty Drawing
1
External
Battery Pack
1 PC
2 User Manual 1 PC
3
Tower Stand
Extender
4 PCS
4 Rail Kit 1 SET
5
External
Battery Cable
1 PC
6 Fastener 1 SET
x2 x8

Amplon RT Series 5
7 Bracket Ear 1 SET x2 x4
x4 x4

Chapter 4 : Installation Procedures
6
Chapter 4 : Installation Procedures
 Rack Mounting
1. Attach the included bracket ears to the lateral mounting holes of the Delta
external battery pack. See Figure 2.
(Figure 2: Mount the Bracket Ears)
2. Follow steps ① to ④ to install the Delta external battery pack in Delta’s
rail kit (provided). See Figure 3.
Step ① : Adjust the length of the rails according to your rack.
Step ② : Tighten the rails’ nuts.
Step ③ : Fix the rails on your rack.
Step ④ : Insert the Delta external battery pack in your rack and
tighten the provided screws.

Amplon RT Series 7
(Figure 3: Insert the Delta External Battery Pack to Your Rack)
NOTE:
If you want to use a non-Delta rail kit, please only follow step ④.
 Tower Mounting
1. Connect your UPS’s tower stands with the provided tower stand
extender(s) according to the width of your UPS and the Delta external
battery pack. See Figure 4.
(Figure 4: Connect the Tower Stands with the Tower Stand Extender(s))
2. Pull out the Delta external battery pack’s control panel ( ① ), rotate
it 90° clockwise ( ② ) and re-insert the control panel. After that,
rotate the Delta logo nameplate 90° clockwise ( ③ ). See Figure 5.