Delta HPH-60K User manual

Delta UPS - Ultron Family
The power behind competitiveness
www.deltapowersolutions.com
HPH Series, Three Phase
60/80/100/120 kVA
User Manual
EPO
ONOFF
NORMAL
BATTERY
BYPASS
FAULT
ESC

II
Ultron HPH Series UPS
Save This Manual
This manual contains important instructions and warnings that you should follow
during the installation, operation, storage and maintenance of this product. Failure
to heed these instructions and warnings will void the warranty.
Copyright © 2016 by Delta Electronics Inc. All Rights Reserved. All rights of this User Manual
(“Manual”), including but not limited to the contents, information, and figures are solely owned and
reserved by Delta Electronics Inc. (“Delta”). The Manual can only be applied to the operation or the
XVHRIWKLVSURGXFW$Q\GLVSRVLWLRQGXSOLFDWLRQGLVVHPLQDWLRQUHSURGXFWLRQPRGL¿FDWLRQWUDQVODWLRQ
extraction, or usage of this Manual in whole or in part is prohibited without the prior written permission
of Delta. Given that Delta will continuously improve and develop the product, changes may be made
to the information in this Manual at any time without obligation to notify any person of such revision
or changes. Delta will make all possible efforts to secure the accuracy and the integrity of this
Manual. Delta disclaims any kinds or forms of warranty, guarantee, or undertaking, either expressly
or implicitly, including but not limited to the completeness, faultlessness, accuracy, non-infringement,
PHUFKDQWDELOLW\RU¿WQHVVIRUDSDUWLFXODUSXUSRVHRIWKH0DQXDO

Table of Contents
III
Table of Contents
Chapter 1 : Important Safety Instructions ------------------------------------------1
1.1 Placement Warnings---------------------------------------------------------------- 1
1.2 Connection Warnings--------------------------------------------------------------- 1
1.3 Usage Warnings --------------------------------------------------------------------- 1
1.4 Storage Warnings ------------------------------------------------------------------- 2
1.5 Glossary of Symbols---------------------------------------------------------------- 3
1.6 Standard Compliance -------------------------------------------------------------- 4
Chapter 2 : Introduction ------------------------------------------------------------------5
2.1 Product Introduction ---------------------------------------------------------------- 5
2.2 Package Inspection ----------------------------------------------------------------- 5
2.3 Functions and Features------------------------------------------------------------ 7
Chapter 3 : Appearance and Mechanism--------------------------------------------9
3.1 Appearance and Dimensions----------------------------------------------------- 9
3.2 Control Panel ------------------------------------------------------------------------10
3.3 Front/ Rear Panel ------------------------------------------------------------------12
Chapter 4 : Operation Modes --------------------------------------------------------- 17
Chapter 5 : Communication Interfaces -------------------------------------------- 21
Chapter 6 : Installation and Wiring-------------------------------------------------- 28
6.1 Precautions Prior to Installation and Wiring ---------------------------------28
6.2 Installation Environment ----------------------------------------------------------28
6.3 UPS Transportation & Handling ------------------------------------------------29
6.4 UPS Installation & Fixing ---------------------------------------------------------29
6.5 Wiring----------------------------------------------------------------------------------32
6.5.1 Precautions Prior to Wiring ------------------------------------------32
6.5.2 Single Unit Wiring ------------------------------------------------------35
6.5.3 Parallel Units Wiring ---------------------------------------------------44
6.6 External Battery Cabinet Connection Precautions -------------------------47
Chapter 7 : UPS Operation------------------------------------------------------------- 52
7.1 Single Unit Operation Procedures ---------------------------------------------53

IV
Ultron HPH Series UPS
7.1.1 Normal Mode Start-up Procedures (Single) ---------------------53
7.1.2 Battery Mode Start-up Procedures (Single) ---------------------53
7.1.3 Bypass Mode Start-up Procedures (Single) ---------------------53
7.1.4 Manual Bypass Mode Start-up Procedures (Single Unit) ----54
7.1.5 Normal Mode Turn-off Procedures (Single) ---------------------55
7.1.6 Battery Mode Turn-off Procedures (Single)----------------------55
7.1.7 Bypass Mode Turn-off Procedures (Single) ---------------------56
7.1.8 Manual Bypass Mode Turn-off Procedures (Single)-----------56
7.2 Parallel Units Operation Procedures ------------------------------------------56
7.2.1 Normal Mode Start-up Procedures (Parallel) -------------------56
7.2.2 Battery Mode Start-up Procedures (Parallel)--------------------57
7.2.3 Bypass Mode Start-up Procedures (Parallel) -------------------57
7.2.4 Manual Bypass Mode Start-up Procedures (Parallel)---------58
7.2.5 Normal Mode Turn-off Procedures (Parallel)--------------------59
7.2.6 Battery Mode Turn-off Procedures (Parallel) --------------------59
7.2.7 Bypass Mode Turn-off Procedures (Parallel)--------------------60
7.2.8 Manual Bypass Mode Turn-off Procedures (Parallel) ---------60
Chapter 8 : LCD Display and Settings --------------------------------------------- 61
8.1 LCD Display Hierarchy------------------------------------------------------------61
8.2 Main Screen -------------------------------------------------------------------------62
8.3 Parallel Screen----------------------------------------------------------------------63
8.4 Main Menu ---------------------------------------------------------------------------64
8.5 Measure ------------------------------------------------------------------------------65
8.6 Maintenance -------------------------------------------------------------------------66
Chapter 9 : Optional Accessories --------------------------------------------------- 69
Chapter 10 : Maintenance -------------------------------------------------------------- 70
Chapter 11 : Troubleshooting --------------------------------------------------------- 71
$SSHQGL[7HFKQLFDO6SHFL¿FDWLRQV--------------------------------------------- 73
Appendix 2 : Warranty------------------------------------------------------------------- 75

1
Chapter 1 Important Safety Instructions
Chapter 1 : Important Safety Instructions
1.1 Placement Warnings
yInstall the UPS in a well-ventilated indoor area, away from excess moisture, heat, dust,
ÀDPPDEOHJDVRUH[SORVLYHV
yLeave adequate space around all sides of the UPS for proper ventilation. Please refer to
6.2 Installation Environment.
1.2 Connection Warnings
yThe UPS must be well grounded due to a possible risk of current leakage.
yIt is necessary to install protective devices when the UPS is connected to the mains and
bypass source. For relevant information, please refer to 6.5.1 Precautions Prior to
Wiring.
yThe protective devices connecting to the UPS must be installed near the UPS and must
be easily accessible for operation.
1.3 Usage Warnings
yThis is a class-A product. In a domestic environment, this product may cause radio inter-
ference, in which case, the user is required to take adequate measures.
yThe UPS can be used to power computers and associated peripheral devices, such as
monitors, modems, cartridge tape drives, external hard drives, etc.
yIf the UPS needs to be connected to a motor load, it must be confirmed by qualified
service personnel.
yIt is strictly forbidden to connect the UPS with any regenerative-type loads.
yThe parallel UPSs can connect with common batteries.
yThe external slits and openings in the UPS are provided for ventilation. To ensure reliable
operation of the UPS and to protect the UPS from overheating, these slits and openings
must not be blocked or covered. Do not insert any object into the slits and openings that
may hinder ventilation.
yIn a low temperature environment (below 0°C), you must allow the UPS to adjust to room
temperature for at least one hour to avoid moisture condensing inside the UPS before
usage.

2
Ultron HPH Series UPS
yThe length of the communication cable must be less than 10 meters. If it is longer than
10 meters, please contact service personnel.
yDo not put beverage containers on the UPS, battery cabinet or any other accessory asso-
ciated with the UPS.
yThe risk of dangerous high voltage is possible when the batteries are still connected to
the UPS even though the UPS is disconnected from the mains. Do not forget to pull out
the battery cable to completely cut off the battery source.
yDo not open or mutilate the battery or batteries. The released electrolyte is harmful to the
skin and eyes and may be toxic.
y'RQRWGLVSRVHRIWKHEDWWHU\RUEDWWHULHVLQD¿UH7KHEDWWHULHVPD\H[SORGH
y$OOPDLQWHQDQFHVHUYLFHVPXVWEHSHUIRUPHGE\TXDOL¿HGVHUYLFHSHUVRQQHO)RUELGRSHQ-
ing or removing the cover of the UPS to avoid high voltage electric shock.
y<RXPXVWFRQWDFWTXDOL¿HGVHUYLFHSHUVRQQHOLIHLWKHURIWKHIROORZLQJHYHQWVRFFXU
1. Liquid is poured or splashed on the UPS.
2. The UPS does not run normally after this User Manual is carefully observed.
NOTE:
If you use the UPS in an area that generates or incurs dust, you should install a dust
¿OWHULQWKH836WRHQVXUHQRUPDOSURGXFWOLIHDQGIXQFWLRQ
1.4 Storage Warnings
yPrior to Installation
If the UPS needs to be stored prior to installation, it should be placed in a dry area. The
allowable storage temperature is between -15°C and +50°C.
yAfter Usage
Press the OFF key ( ) once and the LCD shows the following screen. If you want to
turn off the UPS, please press the DOWN key ( ). Make sure the UPS is shutdown,
disconnect the UPS from the utility power, remove all equipment from the UPS, and store
the UPS in a dry and well-ventilated area at a temperature between -15°C and +50°C.
Idle batteries must be re-charged fully approximately every three months if the UPS
needs to be stored for an extended period of time. The charging time must not be less
than 24 hours each time.
?
6+87'2:1
<(6 12

3
Chapter 1 Important Safety Instructions
1.5 Glossary of Symbols
No. Symbol Description
12QOLQHPRGH/('LQGLFDWRUJUHHQ
2%DWWHU\PRGH/('LQGLFDWRU\HOORZ
3%\SDVVPRGH/('LQGLFDWRU\HOORZ
4)DXOW/('LQGLFDWRUUHG
5ON key
6OFF key
7Goes back to previous screen or cancels current selection.
8Moves down/ Decreases number.
9Moves up/ Increases number.
10 &RQ¿UPVVHOHFWLRQ
11 EPO key
12 R R phase of AC Input/ Bypass Input/ UPS Output
13 S S phase of AC Input/ Bypass Input/ UPS Output
14 T T phase of AC Input/ Bypass Input/ UPS Output
15 N Neutral line of AC Input/ Bypass Input/ UPS Output/ Battery
Input
16 For UPS grounding
17 For critical loads' grounding/ For external battery cabinet's
grounding
18 Positive battery terminal
19 Negative battery terminal

4
Ultron HPH Series UPS
1.6 Standard Compliance
This product meets the following safety standards and electromagnetic compatibility (EMC)
LQVSHFWLRQVWDQGDUGV
yCE
yIEC62040-1
yGB7260.2-2009/ IEC62040-2 C3
yGB17626-2/ IEC61000-4-2 (ESD) Level 4
yGB17626-3/ IEC61000-4-3 (Radiated Field) Level 3
yGB17626-4/ IEC61000-4-4 (EFT) Level 4
yGB17626-5/ IEC61000-4-5 (Surge) Level 4

5
Chapter 2 Introduction
Chapter 2 : Introduction
2.1 Product Introduction
The HPH series UPS is a three-phase four-wire online uninterruptible power supply which
provides reliable and stable sine-wave power to your electronic devices. The UPS applies the
latest design of DSP digital control technology and highest quality assembly, with an output
SRZHUIDFWRUXSWRXQLW\7KHHI¿FLHQF\RIWKHHQWLUHGHYLFHFDQUHDFKXSWRLQRQOLQH
PRGHDQGXSWRLQ(&2PRGH:LWKLWVRXWVWDQGLQJIHDWXUHVWKH836QRWRQO\SURYLGHV
safe, reliable and uninter-rupted power to your sensitive electronic equipment at all times, but
DOVRSURGXFHVJUHDWHUHOHFWULFSRZHUHI¿FLHQF\DWOHVVFRVW7KLV+3+VHULHV836SURYLGHV
four different rated power levels, 60kVA, 80kVA, 100kVA and 120kVA, for your selection.
2.2 Package Inspection
yExternal
During UPS transportation, some unpredictable situations might occur. It is recommended
that you inspect the UPS exterior packaging. If you notice any damage, please
immediately contact the dealer from whom you purchased the unit.
yInternal
1. Check the rating label on the top of the UPS cabinet and make sure the device No.
and capacity match what you ordered.
2. Examine if any parts are loose or damaged.

6
Ultron HPH Series UPS
3. The UPS package contains the following items. Please check if any items are missing.
EPO
ON OFF
NORMAL
BATTERY
BYPASS
FAULT
ESC
EPO
ON OFF
NORMAL
BATTERY
BYPASS
FAULT
ESC
(60/ 80kVA) (100/ 120kVA)
1
2 3 4
56 7
No. Item Q’ty
1UPS 1 PC
2Test Card 1 PC
3Software CD-UPSentry 2012 1 PC
4Key 1 Set
(two copies placed inside the UPS cabinet)
5User Manual 1 PC
6Parallel Cable 1 PC
7USB Cable 1 PC
NOTE:
The balance supports have been locked on the pallet when the UPS is shipped
out of the factory. Please keep them well after unpacking. You might use them for
installation.
4. If there is any damage or anything missing, please immediately contact the dealer
from whom you purchased the unit.
5. If the UPS needs to be returned, carefully repack the UPS and all of the accessories
using the original packing material that came with the unit.