Desa DS37 User manual

Safety Screen Kit DS37, DS41, CDS37,
and CDS41
The Safety Screen Kit contains the following:
• 1-Safety Screen • 2-Lower Screen Clips
• 1-Upper Right Screen Clip • 8-Screws
• 1-Upper Left Screen Clip
If any of these parts are missing or damaged, contact the dealer
where you purchased this kit. If they cannot supply original
replacement parts, call DESA International’s Parts Department
at 1-800-972-7879 for information.
1. Remove the top louver from the fireplace by lifting upward
and out (see Figure 1).
2. Remove the screws from the three tabs at the top of the
glass door. Hold the door securely to keep it from falling
forward.
3. Grasp door by both sides and ease it upward off of the lower
bracket (see Figure 2).
4. Lay glass door assembly on flat surface with the front side up.
Lay the safety screen on top of the glass door assembly with
spline (metal strip around screen) facing up (see Figure 3).
For Installation of Safety Screen Kits for 34", 37", and 41" Fireplace
Figure 1 - Removing/Replacing Top Louver
Figure 2 - Removing Glass Door Assembly
Glass Door Assembly
Lower Bracket for
Door Assembly
Top Louver
Extended Tab
Tab
Figure 3 - Placing Safety Screen on Glass Door
Continued
Spline

105733-01
REV. A
07/99
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
INTERNATIONAL
105733 01
NOT A UPC
5. Locate holes on upper right side of screen. Place upper right
screen clip over safety screen and glass door assembly. Top
flange of screen clip should rest on upper edge of glass door
assembly. Secure with screws (see Figure 4).
6. Install upperleftscreenclipusing the samemethod described
in step 5.
7. Locate holeson lower rightside of screen.Place lower screen
clip over safety screen and glass door assembly. Secure with
screws (see Figure 5).
8. Install lowerleft screen clipusing the samemethod described
in step 7.
9. Replace glass door assembly (with safety screen attached)
by carefully placing it on the lower bracket above the lower
louver. Carefully secure the door by replacing the three
screws into the tabs.
10. To replace the top louver, insert the extended tabs at the top
of the glass door assembly into slots on louver. Gently lower
louver against door.
Figure4-AttachingUpperCliptoSafetyScreenandGlassDoor
Assembly (Right Side Shown)
Safety
Screen
Glass Door Assembly
Screws
This Flange to Rest on Top
of Glass Door Assembly
Right Screen Clip
Figure 5 - Attaching Lower Clip to Safety Screen and Glass
Door Assembly (Right Side Shown)
Safety Screen
Glass Door
Assembly
Screws
Lower Screen Clip