DEVI Devireg 330 User manual

DEVIreg™ 330
(+60 to+160°C)
Electronic Thermostat
Installation Guide
www.DEVI.com

Table of Contents
1 Introduction ............... 3
1.1 Technical Specifications ..... 4
1.2 Safety Instructions ........ 5
2Mounting Instructions ......... 6
3Warranty ................. 7
4Disposal Instruction .......... 7
1Introduction
DEVIreg™ 330 is an electronic thermostat to be installed in
electric cabinets with DIN rail attachment. The thermostat
must be installed via an all-pole disconnection switch. Ei-
ther a wire sensor or an external air sensor must be used to
measure and control the desired temperature.
The thermostat has a button to adjust the temperature set-
ting, with a scale from +60° to +160°C. An LED indicator
shows standby periods (green light) and heating periods
(red light).
More information on this product can also be found at:
devireg.devi.com
DEVIreg™ 330 (+60 to +160°C)
Installation Guide 3

1.1 Technical Specifications
Operation voltage 220-240V~, 50Hz
Standby power consumption Max 0.25W
Relay:
Resistive load
Inductive load Max 16A / 3680W @ 230V cos φ= 0.3 max1A
Sensing units NTC 16.7 kOhm at 100°C
Sensing values:
0°C
25°C
50°C
42kOhm
15kOhm
6kOhm
Hysteresis ± 0.4°C
Ambient temperature 10°C to +50°C
Lowering in economy periods -5°C
Hysteresis range ± 0.75°C
Temperature range +60 to +160°C
Cable specification max 1x4mm2or 2x2,5mm2
Ball pressure temperature 75°C
Pollution degree 2 (domestic use)
Type 1C
Storage temperature -20°C to +65°C
DEVIreg™ 330 (+60 to +160°C)
4 Installation Guide

IP class 20
Protection class Class II -
Dimensions 86 x 36 x 58mm
Weight 83g
The product complies with the EN/IEC Standard "Automatic
electrical controls for household and similar use":
▪EN/IEC 60730-1 (general)
▪EN/IEC 60730-2-9 (thermostat)
1.2 Safety Instructions
Make sure the mains supply to the thermostat is turned off
before installation.
Please also note the following:
▪The installation of the thermostat must be done by an
authorized and qualified installer according to local
regulations.
▪The thermostat must be connected to a power supply
via an all-pole disconnection switch.
▪The sensor is to be considered as live voltage. Have
this in mind if the sensor must be extended.
▪Always connect the thermostat to continuous power
supply.
▪Do not expose the thermostat to moisture, water, dust,
and excessive heat.
DEVIreg™ 330 (+60 to +160°C)
Installation Guide 5

2 Mounting Instructions
Please observe the following placement guidelines:
▪Install the thermostat in an electric cabinet with DIN
rail attachment or a separate DIN attachment accord-
ing to local regulation on IP classes.
▪Do not place the thermostat in a way that it will be ex-
posed to direct sunlight.
Follow the steps below to mount the thermostat:
1. Click the thermostat on to the DIN rail attachment.
2. Connect the thermostat according to the connection
diagram.
IP20
10T50 D330
+60°C to
+160°C
8765
N
4321 L
Mains
220-240V~
250V~
16 (1) A
Sensor
DEVIreg™ 330 (+60 to +160°C)
6 Installation Guide

The screen of the heating cable must be connected to
the earth conductor of the power supply cable by us-
ing a separate connector.
Note: When you use the wire sensor for floor heating,
always install the sensor in a conduit.
3. Turn on the power supply.
3 Warranty
2
Y E A R
4 Disposal Instruction
DEVIreg™ 330 (+60 to +160°C)
Installation Guide 7

DEVIreg™ 330 (+60 to +160°C)
8 Installation Guide

DEVIreg™ 330 (+60 to +160°C)
Installation Guide 9

DEVIreg™ 330 (+60 to +160°C)
10 Installation Guide

DEVIreg™ 330 (+60 to +160°C)
Danfoss A/S
Electric Heating Systems
Ulvehavevej 61
7100 Vejle
Denmark
Phone: [phone]
Fax: [phone]
E-mail: [email protected]
www.DEVI.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its
products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes
being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. DEVI and the DEVI logo-
type are trademarks of Danfoss A/S. All rights reserved.
08091318 & VIGDR202 Produced by Danfoss © 05/2013

DEVIreg 330 +60<>+160°
140F1073
220-240V~ 50-60Hz~ +60 to +160°C 16A/3680W@230V~
Product Documentation
DK EL 7224215328 SE EL 8581188 NO EL 5402664 FI SSTL 3531034
Designed in Denmark for Danfoss A/S
5 7 0 3 4 6 6 2 0 9 2 3 3