Dewenwils HOYS22M User manual

HOYS22M

Align four tabs on stake with four holes on back of timer. Push
tabs down, then up, until they lock into place. Shown as Figure

Overload Protection
Switch
Grounded Outlets
Timer Dial
Manual Override
Switch
1.Set the current timer: Turning dial clockwise until the arrow indicates
to current time.
2. Begin with all pins inner ring. Push the pins out for the periods of
time you want the timer to be ON. Pins in outer ring represents ON
and inner ring represents OFF.
Note: Pins indicated by the arrow can not be push out, rotate the
dial to make it work
3. Push the manual override switch to “ ” position and plug the timer
into the wall socket. You may override operation of the timer by
setting the switch to “ ” position. The power supply will always
be ON. Be sure to set switch back to the “ ” for proper timer
function.
4. Plug your electrical device directly into the timer. Make sure the
device is in ON state so the timer can control it to work properly.
5. If blackout, reset the time as indicated above.

15A Resistive
600W Tungsten
1/2 HP
14/3C