Rev. 4208 Page 3/ 5
I-301
DIGITAL TIMER WITH 1 ADJUSTABLE TIME
THROUGH PUSH BUTTON
10 –Timing with Delayed activation and reactivation through push button
Closing the START button, the timing is activated without connecting the relay. If during the timing the START button is
activated, the timing is reset and the time start once again. At the end of the time, the relay is connected and it will
maintain this activation till the module is supplied.
11 –Timing with Delayed activation and cumulative through push button
Closing the START button, the timing is activated without connecting the relay. If during the timing the START button is
activated, another time period is cumulated. At the end of the time, the relay is connected and it will maintain this
activation till the module is supplied.
12 –Activation delay through push button (Equivalent to I-38 and I-39)
Closing the START button, the relay is activated without timing. Opening the START button the timing is activated and it
will maintain this activation till the end of the selected time.
13 –Activation delay and Reactivation through push button
Closing the START button, the relay is activated without timing. Opening the START button the timing is activated and it
will maintain this activation till the end of the selected time. If during the timing the START button is closed, the timing is
reset and the time start once again.
14 –Activation delay and Cumulative through push button
Closing the START button, the relay is activated without timing. Opening the START button the timing is activated and it
will maintain this activation till the end of the selected time. If during the timing the START button is closed, another
period is cumulated.
PUSH BUTTON for TIME INDICATION
, => To add 0,1 sec to the programmed time
=> To add 1 sec to the programmed time
=> To add 10 sec to the programmed time
=> To add 100 sec to the programmed time
TIMING PROGRAM
IMPORTANT. From our factory, the timer is supplied without any type of preregistered timing, neither operating time. You
will have to program the timing before using it for the first time.
By not making any programming, the timer will function in mode type 2, time 3 seconds.
STEPS TO PROGRAM THE TIMER
Connect the power supply, the POWER Led will lighted on. Maintain pressed for 2 seconds the ON Key. At this moment the
ON Led will permanently lighted on, to indicate the circuit is in programming mode.
Select through TEMPO TYPE Dips the required model.
Pressing as time as you wish the time buttons, with each pressure the PUL Led will light and cumulate the time of the
selected push button. For instance, to Select 32 seconds, you have to press 3 times the button and then 2 times the
button, the total will be 32.
Once indicated the required time, press ON push button till ON Led will intermittently light on 3 times to indicate the
correct time recording. Then, the timer will be programmed and ready to operate.
Attention. If you have selected a model starting though voltage, as soon as you will connect the power supply, the module
will be activated.
