Dewenwils HODT13E User manual

HODT13E
Outdoor Light Sensor Timer
Please pay attention to the warning signs
Read the instructions with caution before operating
and keep it properly
V20621

WARNING :
To reduce the risk of fire, electric shock or personal injury,
please strictly follow the instructions.
1. The device must be mounted in a vertical position with the receptacle
facing downward and with the receptacle at least 2FT above the ground
level.
2. Do not connect any devices which exceed the maximum ratings of
the timer.
3. Do not immerse in water.
4. Children are not allowed to use the timer without supervision.
5. Do not disassemble or repair the product, but only by authorized
service personnel.
6. Always unplug and store indoors when not in use.
1. Timer dial:2 to 8 hours or dusk
to dawn and daily repeat function.
2.Sensor:Sensor will turn timer on
at dusk and off at dawn.
3. Power:Power indicator light
indicates if the timer is turned on
or off.
Product Layout
1
2
3

Specifications:
Input Voltage:
- 125V, 60Hz.
Max Power Rating:
- 125V, 60Hz, 1875W,
- 15A Resistance,
- 15A General Use,
- 1000W Tungsten,
- 500VA Electronic Ballast,
- 120Vac, 60Hz, 8.3A Ballast,
- 1/2HP.
Cord:
- 25FT SJTW 14/3 AWG.

3
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
One Year Limited Warranty
Supported by our professional R&D team and QC team, we provide One
Year Warranty for materials and workmanship from the purchase date.
Please note that the warranty does not cover damage caused by personal
misuse or improper installation.
Please attatch your Order ID and Name so that our dedicated customer
service team can help you better.