Dimplex Duo300i User manual

Dimplex DuoHeat Radiator - Quick Start Guide
for Models: Duo300i, Duo400i and Duo500i
Quick Start Guide - Setting the Controls
86484 Issue 1
DuoHeat has two output modes Comfort (Radiant Heat) and
Background (RetainedHeat). Eachneeds to beset to thecorrect
level to provide the optimum level of comfort.
For DuoHeat to operate correctly, both electricity
supplies must be switched on at all times.
Initial Set Up
Depending on your comfort requirements, there are three
recommended settings:
Low (e.g. holiday home during period of vacancy)
Normal (e.g. typical use)
High (e.g. sheltered accommodation).
Both the Comfort and Background heat settings need to be set
accordingly.
"Normal" Setting
This is the factory default setting, however you should check this
has not been altered by the installer.
Set the Background setting at the mid point (5th bar). To do
this, press the ++
++
+button until 10 bars are illuminated and continue
to hold for a further 7 seconds. Adjust by pressing the ++
++
+or --
--
-
buttons.
After 20 seconds, the display will revert to the standard Comfort
mode.
Set the Comfort control at the mid point (5 bars) by pressing the
++
++
+or --
--
-buttons to change the number of illuminated bars.
“Low” Setting
Reduce the Background setting to 1 bar.
Reduce the Comfort control to 1 bar.
Achieving Optimum Comfort Level
Iftheroomisnotatthedesiredtemperatureintheafternoon/evening:
Adjust the Comfort heat level up or down accordingly.
If the room is not at the desired temperature in the morning:
Adjust the Background level up or down accordingly.
Operate the radiator for 24 hours before making further
adjustments to the settings.
When making adjustments to the Background setting, it is
recommended that you do not change the setting by more
than one bar at a time.
Everyday Operation
Once the Background level has been set (seeAchieving Optimum
Comfort Level above), this should not require any further
adjustment.
Adjust the Comfort setting as required to suit your comfort needs
and occupancy pattern. The control can be lowered slightly (we
recommend by no more than 2 bars) to save energy when the room
is unoccupied and increased again when more heat is needed.
For more comprehensive advice on using your DuoHeat radiator,
please refer to the Operating Instructions.
Low Normal High
Low Normal High
“High” Setting
Increase the Background setting to 7.
Increase the Comfort control to 7.
Please note that at high setting the room temperature will be
warmer with a corresponding increase in running costs.
Operate the radiator for 24 hours before making further
adjustments to the settings.
FlashingBar FlashingBar
Glen Dimplex UK Limited
UK customer helpline (8.00AM - 6.00PM Mon-Fri; 8.30AM-1.00PM Sat)
Customer Help Line Tel: [phone]
Fax: [phone]
e-mail: [email protected]
Republic of Ireland Tel: [phone]