Diono Radian 5 User manual

Aircraft Instruction Manual
Please read carefully
convertible car seat
®

FORWARD-FACING AIRCRAFT INSTALLATION
DO NOT use the detachable base when Radian 5 is used
forward-facing.
DO NOT place an infant in a forward-facing Radian until they
are at least 9 kg.
ALWAYS use Safe Stop and 15-25 kg harness pads for forward-facing
children over 15 kg.
ALWAYS install Radian on the seat next to the window to allow access
for other passengers.
ALWAYS ensure the armrest can be moved to the down position once
the car seat is installed.
IMPORTANT:
ONLY install this child restraint on aircraft passenger seats approved for
this purpose.
The aircraft installation method is only suitable for use on an aircraft.
DO NOT install Radian in a car using this method.
ALWAYS contact your airline before travel if you intend to take
a child restraint.
ALWAYS keep Radian restrained, even when unoccupied. An
unrestrained child restraint can endanger other passengers in the case
of turbulence.
DO NOT install this child restraint within the deployment area
of airbags.
DO NOT install using a lap belt with airbag
Safety of the child will not be ensured if the instructions for installation
and use are not observed.
1. Install a seat belt extender.
Remove all the slack from the
seatbelt, extend the
seatbelt extender to its
full length and attach to the
seatbelt on the side furthest
away from the aisle.
Radian 5 is approved by TUV for use on aircraft forward facing from 9 -25 kg
as a harnessed restraint. An aircraft seatbelt extender will be necessary.
2. Unfasten fabric side panels and
reach behind the cover for easy
access to the belt path. Place
Radian in a forward-facing
position with the entire bottom
at on the aircraft seat and back
of the car seat at against the
aircraft seat back. A gap is
acceptable as long as the top of
the car seat is rmly touching
the aircraft headrest or seat back.
4
2

english
3. Starting from the outside
slide the seat belt through
the forward-facing belt path
behind the fabric and out of the
opposite side. Be sure the belt is
not twisted.
4. Connect the buckle to the
latch plate.
5. Push down on the bottom of
the car seat while pulling all the
slack out of the belt. It is best to
do this close to the buckle. Be
sure car seat does NOT move
more than 1 inch side-to-side,
front-to-back at the belt path.
6. In some cases, it may not be
possible to tighten the aircraft belt
enough. Certain lengths of xed
belts mean the buckle could rest on
the Radian-belt-guide. A seatbelt
shortener (available separately)
can be used. Slide the seatbelt
into one open side of the metal
shortener (A). Repeat for the
other side so that the clip is rmly
attached to the belt (B). Now turn
the metal shortener over, fold the
seatbelt back on itself and slide
into the visible opening on the
shortener to x in place (C). This
can be repeated to further shorten
the belt as required.
(A)
(B)
(C)
5
3

convertible car seat
®
Groups 0, 1, 2
Universal Birth to 18 kg
Semi-Universal 15 to 25 kg
02212017
product: radian®5
convertible car seat
model: 120000
mfg. by: Diono UK
Unit D Ventura Park Road
Tamworth, B78 3LZ
United Kingdom
GB 00000-0000
Customer Service
Tel: [phone]
Email: [e-mail]
uk.diono.com
© 2017 diono LLC. All rights reserved.