Diphano Icon User manual

Icon
dining table 164x96
ceramic
INSTRUCTION MANUAL

2
CONTENT
how to assemble the dining table
1x table top 1x support
8x bolt (M8x20mm)
A B
E
4x bolt (M8x15mm)
1x hex key
4x leg
8x washer (8mm)
4x adjuster
D
G
C
F
H
Start by unpacking everything carefully. Make sure to cover the floor to prevent any
damage or scratching (you can use the cardboard box for this).
Diphano cannot be held responsible if the assembly instructions are not followed properly.

3
CONNECT THE LEGS (1/2)
Connect the legs (C) to the support (B) by fixating the bolts (E) with the washers
(F) in the correct order. Repeat this action for each leg.
1
F
E
G

4
CONNECT THE LEGS (1/2)
Fixate by screwing the bolt (D) into the pre-made hole.
Repeat this action for each leg.
2
F
D

5
TURN TABLE
Turn the table carefully to its normal position with at least 2 persons.
3

6
ADJUST FEET
Check with a spirit level if the table is placed level. If not, (un)screw the adjustable
feet till your table is completely level.
It is important to prevent tension on your ceramic top!
4

7
PLACE TABLE TOP
Carefully place the table top (A) onto the support (B) with at least 4 persons at the
positions indicated in the picture.
5

8
POSITION TABLE TOP
Carefully adjust the ceramic top into the correct position. 2mm tollerance around the
leg is required, see detail. If this is not possible, please go to the next chapter.
6
LEG ca. 2mm
CERAMIC

9
In case there is not enough space between the legs to place the
ceramic table top in a safe way, there are adjusters included.
Follow the steps below to adjust your table.
how to adjust the table top
DECONNECT THE LEGS
Deconnect the legs that do not have enough space between the leg and the ceramic
table top.
1

10
POSITION ADJUSTER
Peel o the strip of the sticker on the adjuster and stick the adjuster on the open
outer profile of the leg so the pre-made holes match.
Now go back to step 1 ‘connect the legs’.
2
STICKER

11
maintenance & care
POWDERCOATED ALUMINIUM
Simply brush away loose dirt, rinse, and clean with a mild, lukewarm
soapy solution. Rinse thoroughly and pat dry with a cloth.
Simply brush away loose dirt, rinse, and clean with a mild, lukewarm
soapy solution or Ceramic cleaner. Rinse thoroughly and pat dry with a cloth.
Glass, ceramic, Trespa® cleaner & polisher
Makes hard surfaces repellent to water, moisture and dirt.
Cleans and removes stains without scratching using the included cloth.
CERAMIC

PIDE220530
www.diphano.com
Textielstraat 4 - 8790 Waregem - Belgium
Tel. [phone] - [email protected]