Diphano SELECTA User manual

1/2
INSTRUCTION PAPER
SELECTA | High dining table M 226x90
CONTENT
8x bolt (M8x40mm)
4x bolt (M6x15mm)
18x bumper
2x alu legs
4x spring washer (M6)
18x washer (2mm) 1x alu table top support
8x spring washer (M8)
4x washer (M6)
18x washer (1mm)
1x table top
8x washer (M8)
1x hex key (5)
1x hex key (6)
A
E
I
M
B
F
J
N
C
G
K L
D
H
STEP 1: ASSEMBLE LEGS STEP 2: TURN TABLE
FC
HEG
D
A
B
Slide the outer legs (M) equally onto the table top (L). Fixate the legs
by screwing the bolts (A,E) with the washer (B,F) and spring washer
(C,G) using the hex keys (D,H). Make sure you follow the correct order
as indicated by the letters in the picture. Repeat this action for the
other side.
Turn the table carefully to its normal position with at least 4 persons.
Start by unpacking everything carefully. Make sure to cover the floor to prevent any damage or scratching (you can use the cardboard box for this).

INSTRUCTION PAPER
SELECTA | High dining table M 226x90
2/2
PIDE210120 Diphano cannot be held responsible if the assembly instructions are not followed properly.
www.diphano.com
DINING
ARMCHAIR LOUNGE CHAIR FOOTREST BEACH CHAIR DECK CHAIR
DINING TABLES HIGH DINING TABLES EXTENDABLE TABLE
LOUNGERS
BISTRO TABLES
108 | 92 | 74h
STEP 3: PLACE BUMPERS
J or K
I
Place the bumpers (I) with the washers (J,K) on the correct positions as shown on the topview on the right. Check during setup which washer
is neccessary for adjusting the glass top on the frame, the 1mm or the 2mm.
STEP 4: PLACE TABLE TOP STEP 5: ADJUST FEET
Carefully place the table top (N) in the lower part of the support with
at least 4 persons.
Check with a spirit level if the table is placed level. If not, (un)screw
the adjustable feet till your table is completely level.