Displays2go DGMLTSBK User manual

If you have any questions regarding our products, please visit us at www.displays2go.com or contact D2g customer service 1-844-221-3393.
Max Load: 265 lbs
WARNING:
Unplug the power cord while not using.
Keep hands and fingers clear of the moving parts.
Keep out of reach of children.
Scan QR code to visit
the product page:
ASSEMBLY INSTRUCTIONS
DGMLTSBK - Motorized Tilt Digital Signage Stand
V21.03
1 of 8

2 of 8
Part List:
H.4pcs
D. Remote Control 1pc
(1 battery included)
Replacement battery: 1X A23
I.4pcsJ.M8×16 6pcsK.M8 6pcs
E.M6 wrench F.M8×10 8pcsG.M8 8pcs
M4x16 8pcs
M4x25 8pcs
M5x16 8pcs
M5x25 8pcs
M6x20 6pcs
M6x40 6pcs
M6x55 6pcs
M8x20 6pcs
M8x40 6pcs
M8x55 6pcs
12pcs
L. Screw
M.WashersN.Spacers
M5×8pcs1/4"×6pcs M8×6pcs
1pc
A.1pcC.1pcB.2pcs

A
1. Plug the power cord into the power outlet. 2. A steady red light indicates the unit
is powered on.
3. Push the buttons on the base to adjust the angle and height.
3 of 8

4. Attach the mounting bracket to the top of the stand and secure it with hardware as shown.
Top side.
E
JK
C
4 of 8

TV
L
M
N
B
N
H
G
I
F
L
M
TV
5.a Attach the mounting brackets to the back of your display signage. Use spacer as needed.
5.b For oversized digital signage, use extension brackets as shown.
5 of 8

Min: 15.75”
Max: 35.5”
6. Carefully hang your digital signage onto the bracket on top of the stand. Secure the signage by
fastening the screws with a phillips screw driver as shown.
6 of 8

D
7.a In case the remote control is not linked to the stand,
use a small pin to press the link button besides the
indicator light .
7.b While the indicator light is flashing, press
the button shown below on the remote control
and it is now paired to the stand.
7 of 8

8. You can set your digital signage at the desired height and adjust the angle of display using
either the remote control, or the control button on the base.
8 of 8