Displays2go QSCT1117WD User manual

Assembly InstructionsAssembly Instructions
SNAP FRAME POSTER HOLDERSNAP FRAME POSTER HOLDER
SKUs: QSCT1117WD, QSCT1117SV,SKUs: QSCT1117WD, QSCT1117SV,
QSCT8511WD, QSCT8511SVQSCT8511WD, QSCT8511SV

2
PARTS LIST
PART QUANTITY
A: Poster Frame .....................................................................................................1
B: Base Plate..........................................................................................................1
C: Square Pole ......................................................................................................2
D: White Washer...................................................................................................2
E: Black Knob Screw ............................................................................................2
F: 3mm Hex Screw................................................................................................2
REQUIRED TOOLS: 3mm Allen wrench (not included)
If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
Scan QR code
to visit product
page
NUMBER
PART
Information in this drawing is provided for reference only.
http://www.mcmaster.com
5.5 mm
2.5 mm
Hex
3 mm
3 mm 10 mm
M3 x 0.5 mm Thread
90035A112
High-Strength A286 Stainless
Steel Socket Head Screw
© 2021 McMaster-Carr Supply Company

3
2. Tighten both screws securely, using an Allen wrench (not included).
3. Insert knob screw through the hole (shown at right) on the poster frame. Slip the
washer onto the screw. Repeat for both sides of the frame.
1. Insert screws into holes on the base plate of the unit, then affix it to the square pole. Repeat
for both square poles. (This will require an Allen wrench.)

4
4. Tighten knob screw into the square pole. Repeat for both square poles.
Eny r w poer her!Eny r w poer her!
CONTACT INFORMATION:
www.displays2go.com
PHONE: [phone]