Docking Drawer QUAD 5030-1333 User manual

5030- Flush Pop Up Outlet
Installation Instructions
How to Install the Outlet
Step 1 - Select a location for the pop-up outlet that
meets the following requirements:
• The edge of the cut out should be at least 40mm
from the nearest wall.
• A power outlet should be within 1.5 meters of the
installation cut out for the power cord to reach.
• Benchtop thickness is between 10-45mm.
• Consult the following illustrations to ensure there is
sucient space underneath the benchtop.
Step 2 - Cut a
95mm hole in
the surface of
the benchtop to
create the installation
cut out.
of space needed
under benchtop
benchtop
thickness
Cut out size
326mm
10-45mm
QUAD
5030-1333
5030-1133
TRIO
5030-1330
5030-1130
DUO
5030-1300
QUAD
5030-1333
5030-1133
TRIO
5030-1330
5030-1130
• For indoor use only.
• Avoid liquid spills into the outlet.
• When using the wireless charger, do not place
metal objects, magnets, magnetic stripe cards, etc.
• Be sure to ground connection.
• Do not disassemble the unit.
• If the product has malfunctioned, electrical
maintenance is required by a professional.
CAUTION – READ CAREFULLY
95mm
Downloadable Resources
For additional planning resources, visit
dockingdrawer.com/downloads
• Spec Books
• Tear Sheets
• Electrical Certications
• Cut Out Templates
DUO
5030-1300
of space needed
under benchtop
benchtop
thickness
277mm
10-45mm
of space needed
under benchtop
benchtop
thickness
227mm
10-45mm
Outlet #1
Release
Button
QI Wireless
Charging Top
Tower
1 USB-C (PD)
& 1 USB-A
Outlet #2
Outlet #3
Base
Ring
Adjustable
Ring

To Open - Press the center of the top and the
outlet will pop up. Lift the outlet until it locks into place.
Wireless Charging - Place the device gently
in the center of the top cover. Compatible with all QI
enabled devices. Ensure that there are no metallic
foreign objects on the charging pad. If you’re having
an issue charging a device, remove the device case, if
any, as it may block the wireless signal.
To Close - Press the “Push to Release” button to
partially retract the outlet. Then press the top of the
outlet to push the rest of the tower into the benchtop
and to lock into place.
Install Docking Drawer in-drawer outlets into any
drawer to clear benchtop cord and device clutter and
bring purpose to your drawers. Docking Drawer Trio
outlets are Australian Certied for Safety and EMC.
How to Use the Outlet Also Available from Docking Drawer
Scan code to
learn more
Docking Drawer Trio
Step 3 - Rotate the adjustable ring in a counter-
clockwise direction to remove. Place the power cord
through the installation cutout and then insert the
base of the outlet into the cut out. Be careful to avoid
damage to power cord.
Step 4 - Adjust the front of the product to face
the desired direction. Under the benchtop, rotate the
adjustable ring in a clockwise direction to tighten. Note
that when the adjustable ring is askew, it will get stuck.
If this occurs, re-tighten after alignment.
Step 5 - Connect the power cord to a power source
within 1.5m, ensuring the outlet can open and close
without tension on the cord.
AG11021
[email protected]
www.dockingdrawer.com
[phone]


