Dogtra IQ CLIQ User manual

1
iQ CLiQ
EXPANDABLE TO 2-DOG SYSTEM
Owner's Manual
Please read this manual thoroughly before
operating the iQ CLiQ training e-collar.

2
WARNING
Please read all safety and product information below
before using your Dogtra product. Failure to follow these
safety instructions could result in injury to you, your dog
and others, or it could result in damage to your Dogtra
product or other property.
PRODUCT SAFETY
Training Methods
Dogtra products may be used with a variety of training
methods. However, each dog may have a different reaction
to training methods and to Dogtra products. Closely observe
your dog when determining the right training method to use
with your Dogtra product.
Aggressive Dogs
Do not use Dogtra products with aggressive dogs as such
dogs may react adversely and cause injury to people or
other dogs. Seek the assistance of a dog-training specialist
or veterinarian when dealing with aggressive dogs.
Children
Dogtra products are not toys. Adult supervision and close
attention are necessary when Dogtra products are used by
or near children.
PRODUCT DAMAGE
Electrical Product
Your Dogtra product contains electrical components and
batteries. Do not use or keep your product near heat or
flammable sources. Such use or storage may damage your
IMPORTANT SAFETY AND PRODUCT
INFORMATION

3
product and/or cause fire, explosion, injury, or property
damage.
Medical Device Interference
Dogtra products contain electrical and magnetic
components that emit low level electromagnetic waves
and radio frequencies. These electromagnetic waves
or radio frequencies may interfere with pacemakers,
defibrillators, or other medical devices. Consult your
physician or medical device maker before using your
medical device with a Dogtra product. If you think that
your Dogtra product is interfering with your pacemaker,
defibrillator, or other medical device, stop using the
Dogtra product.
Inadvertent Activation
The digital microprocessor offers thousands of unique
codes to eliminate frequency match-up with other Dogtra
e-collars. The Constant button will automatically shut
down after being held down for 12 seconds or more as a
safety feature.
UNAUTHORIZED USE
Your Dogtra product should be used only in a humane
manner to train and educate your dog. Dogtra products
are not intended for use in any other manner nor are they
intended for use with other animals or with humans.
BATTERY
Your Dogtra product contains batteries. Take care when
removing and installing batteries as your fingers may get
caught. Dispose of batteries as provided by your local
regulations. Do not disassemble, crush, heat, or otherwise
alter the battery as it may cause fire, injury or property
damage.

4
CONTENTS
AT A GLANCE ..................................................................
MAIN FEATURES ............................................................
OVERVIEW .......................................................................
UNDERSTANDING YOUR TRAINING SYSTEM
TURNING THE iQ CLiQ ON/OFF ..........................
TRANSMITTER BUTTON FUNCTION ..................
RECEIVER FITTING .................................................
FINDING THE RIGHT STIMULATION ...................
MAXIMIZING THE DISTANCE ................................
LED INDICATOR .......................................................
REPLACING THE BATTERY ...................................
ATTACHING THE COLLAR STRAP ......................
CODE SETTING ........................................................
GENERAL TRAINING TIPS ...........................................
MAINTENANCE ...............................................................
TROUBLESHOOTING GUIDE .......................................
WARRANTY AND REPAIR INFORMATION .............
5
6
7
9
10
11
12
13
14
15
17
18
19
22
23
24
1.
2.
3.
4.
5.
6.
7.
8.
9.

5
AT A GLANCE
Optional Accessories
To purchase optional accessories, please visit
www.dogtra.com or call our customer service
at [phone].
Keep batteries away from small children. If a child swallows a battery,
please consult a physician or your local poison control immediately.
WARNING
Transmitter Receiver Detachable Strap
3V Coin Batteries (4)
(CR 2032)
Owner’s
Manual

6
MAIN FEATURES
• Expandable to 2-Dog System
• Clicker
• Replaceable Coin Lithium Batteries Included
• Fully Waterproof Receiver
• Water-Resistant Handheld Transmitter
• 100-Yard Range
• 100-Level Front-Facing Dial
• Conductive Plastic Contact Points
• Reduced Size Receiver
• Detachable Collar Strap

7
OVERVIEW
Rheostat Dial
LED Indicator
On/Off Magnetic
Red Dot
Dog 1
Stimulation
Dog 2
Stimulation
Clicker
Battery Cover
Antenna
iQ CLiQ
Transmitter

8
Detachable Collar Strap
Conductive Plastic Contact Points
Battery Cover
On/Off Magnetic
Red Dot
LED Indicator
iQ CLiQ
Receiver

9
To turn the receiver on, place the red dot on the back of
the handheld transmitter to the red dot on the receiver.
Hold the two red dots together for a moment until the
LED light on the receiver comes on.
To turn the receiver off, repeat the same procedure
holding the two red dots together momentarily. The LED
light will turn red for a brief moment indicating that the
receiver is now off.
The handheld transmitter does not have an on/off button
and it will only activate when the buttons are pressed.
UNDERSTANDING YOUR TRAINING
SYSTEM
1. Turning the iQ CLiQ On/Off

10
2. Transmitter Button Function
Stimulation is sent to the receiver by pressing one of the
buttons on the handheld transmitter. The number on the
button controls the corresponding receiver.
Button 1 - Dog 1
Stimulation Button
When the Dog 1 Stimulation
Button is pressed, the
corresponding receiver will
receive a momentary burst
of stimulation. Holding
down this button will send a
pulsating stimulation for up to 5 seconds. The stimulation
will automatically shut off when the button is pressed for
more than 5 seconds.
Button 2 - Dog 2 Stimulation Button
When the iQ CLiQ has been expanded to a 2-dog system,
the Dog 2 Stimulation Button will send a momentary burst
of stimulation to the corresponding receiver. Holding down
the stimulation button will send a pulsating stimulation for
up to 5 seconds. The stimulation will automatically shut
off when the button is pressed for more than 5 seconds.
When a button is pressed, the LED will illuminate on the
handheld transmitter and the corresponding receiver.

11
3. Receiver Fitting
Proper Fit
The receiver should be fitted so that the conductive
plastic contact points press firmly against the dog’s skin.
You should be able to fit two fingers underneath the
collar strap. The best location is on either side of the dog’s
windpipe.
Improper Fit
A loose fit can allow the receiver to move around on the
dog’s neck. When this happens, the contact points may
rub against the skin and cause irritation. If the receiver is
too loose, the contact will not be consistent and cause the
corrections to be inconsistent.
Attention!
Leaving the receiver in the same location on the dog’s
neck for an extended period of time can cause skin
irritation due to the sensitivity from the contact points.
If the dog is to wear the receiver for long periods,
occasionally reposition the receiver every few hours so
that the contact points are moved to a different
location on the dog’s neck and remove the receiver
after eight hours of usage. Make sure you check for skin
irritation each time you use the unit.

12
4. Finding the Right Stimulation
The iQ CLiQ has a Rheostat
Dial on the front of the
transmitter (0 is the lowest
and 100 is the highest).
Remember that you will
need to adjust the setting
(upward or downward)
depending on your dog’s
temperament and threshold for stimulation. Always start
at the lowest level and work your way up. The appropriate
level can be found when the dog responds to the
stimulation with a mild reaction. Also, as the dog’s attitude
changes, especially during times of increased excitement
or distraction, you may need to adjust the intensity level.
Note: The stimulation intensity can be adjusted even when
the stimulation is in use.

13
5. Maximizing the Distance
The iQ CLiQ has a 100-yard range. Depending on the way
you use your transmitter, the transmitter range may vary.
To get the greatest range, hold the transmitter away from
your body and avoid touching the antenna. Keep your
unit properly charged for maximum signal strength.
Typical range
Maximum range Minimum range

14
6. LED Indicator
When the receiver is on and ready to operate, the LED
flashes every 4 seconds. The LED will glow steadily on
both the handheld transmitter and the receiver while any
buttons are pressed.
The LED color indicates the battery life level.
Green = Sufficient charge, Red = Replace battery
The LED on the handheld transmitter and receiver also
indicates the remaining battery life, with a green LED
meaning sufficient charge, and a red LED meaning the
battery needs to be replaced.
If the LED does not illuminate when a handheld
transmitter button is pressed, the unit may need battery
replacement.

15
7. Replacing the Battery
- Using a coin, unscrew the battery cover counterclockwise.
- Insert two batteries with both of the (+) plus sides facing
upwards.
- Check to make sure that the rubber O-ring is in place and
screw in the battery cover clockwise.
- Using a coin, unscrew the battery cover counterclockwise.
- Insert two batteries with both of the (+) plus sides facing
upwards.
- Check to make sure that the rubber O-ring is in place and
screw in the battery cover clockwise.

16
* ATTENTION
- When the batteries are placed incorrectly, the LED
indicator light may turn on, but the unit will not
operate properly.
- The unit is working properly when the LED battery life
indicator blinks once every 4 seconds.
- Make sure to remove the protective plastic battery
seals before installing the batteries.

17
* For video instructions on how to attach the collar strap,
please visit www.dogtra.com
8. Attaching the Collar Strap
1. With the LED indicator
and red dot facing up, insert
the left portion of the iQ
CLiQ receiver box into the
collar strap.
3. Be sure that the collar
strap is wrapped fully
around the receiver box
of the iQ CLiQ.
Hold strap here Hold strap here
Pull the strap around the body
of the iQ CLiQ in the direction
shown.
2. Pull the collar strap firmly
around the rest of the iQ
CLiQ receiver box.

18
9. Code Setting
1. On the transmitter, set the Rheostat Dial to 0 and hold
down the buttons 1 and 2 simultaneously for 5 seconds
until the green LED blinks rapidly on the transmitter.
2. With the receiver turned off, place the red dot on the
back of the transmitter to the red dot of the receiver
you would like to code. Hold the two red dots together
until the green LED blinks rapidly on the receiver.
3. While the green LED is rapidly blinking on the receiver
and transmitter, separate the two devices and press
either the 1 or 2 on the transmitter depending on which
number you would like to code. The LED light on the
receiver will blink every 4 seconds when coding is
complete.

19
Your dog must know some basic obedience commands
before beginning training with the iQ CLiQ. A dog learns
by first being shown a command, followed by lots of
repetition over an extended period. As the dog becomes
proficient at these commands, the trainer can introduce
distractions and different locations to strengthen them.
Obedience Training on the Leash
Your dog must fully understand the obedience commands
(sit, stay, here, heel, and kennel) before using the e-collar
for reinforcement of these commands. A leash attached
to a standard collar is used to "teach" the dog the basic
obedience commands (here, heel, sit, and stay). A tug
on the leash/collar is used to reinforce the command.
When the dog complies with the command, use positive
reinforcement/praise. Once the dog understands these
commands, the e-collar can be used to reinforce them.
Training with the Clicker
1. Why a clicker?
Since its introduction to dog training in the early 90s,
the clicker has become a go-to tool among pro trainers
and pet owners alike. Its utility as a training aid has been
proven across a wide range of disciplines, including
formal obedience and behavior modification.
2. Positive reinforcement and marker training
Positive reinforcement strengthens correct behaviors
by rewarding them. Rewarding your dog for a job
well done is an important part of every sound training
method, and as with effective punishment, good timing
is critical. However, timing a reward with precision can be
GENERAL TRAINING TIPS

20
challenging, especially when delivering a toy or treat from
your pocket.
The clicker, which makes a noise that is perfectly
consistent and distinct, eliminates this problem by
marking the exact moment your dog does something
correctly. Clicking right as the behavior is occurring tells
your dog that what he is doing in that moment has earned
him a reward. You may then deliver the reward shortly
afterward (a two second interval is best), even if the dog
has moved on to some other behavior.
3. Getting started with your clicker
To teach your dog what the click means, practice clicking
and then treating. Repeat until your dog clearly recognizes
the sound and responds with a look of anticipation.
4. Capturing and shaping
You may select any behavior your dog does on his own
and put it on cue, by clicking and rewarding when you see
it. Take picking up a toy or lying down. By clicking and
rewarding, you mark the behavior as something worth
offering. Repeat until your dog offers it frequently enough
that you can cue it ahead of time. Your dog will associate
the cue with the selected behavior, after which you only
click and reward it when performed on cue.
To shape new skills, begin by clicking and rewarding the
closest behavior you are able to observe or elicit. As your
dog offers it more reliably, gradually raise the bar, only
clicking and rewarding those examples that come closest
to the mark.
Your dog should enjoy working to earn clicks, and doing
so should develop his mind more fully.