Dogtra Edge User manual

4 1
By Dogtra
Remote Controlled Dog Training Collars
Owner's Manual
Please read this manual thoroughly before operating the Dogtra
EDGE training collar.

2 3
Intended Use
Dogtra e-collars are intended for behavior modication on dogs only.
They are NOT intended for use on people or on animals other than dogs.
Dogtra does not assume any liability for the improper use of any Dogtra
e-collars.
Aggressive Behavior
Dogtra highly recommends consulting a dog training professional when
using an e-collar to correct dogs that are aggressive towards people or
other dogs.
Electronic Interference
Dogtra’s industry-leading technology ltering system ensures minimal
interference with other electronic devices (garage door openers, mobile
phones, etc.). Our digital microprocessor offers thousands of unique
codes to eliminate frequency match-ups with other Dogtra e-collars.
Dogtra recommends consulting your physician if you are going to use
the e-collar near any types of medical devices.
Safety Cut-off
The constant stimulation will only activate for a maximum of 12
seconds. After 12 seconds of continuous stimulation, the stimulation will
reset. The stimulation reactivates once the constant button is released
and pressed again.
Proper Fit
A proper t is necessary for the Dogtra e-collar to work optimally. Both
contact points must be in contact with your dogs skin at all times for a
Product Safety and Health Statement consistent stimulation. A loose tting collar can cause the contact points
to rub against the skin and cause irritation.
Duration your dog can wear the unit
Leaving the e-collar in the same position on a dog’s neck for extended
periods of time can also cause skin irritation. To prevent this,
occasionally reposition the e-collar so the contact points are moved
to a different location on the dog’s neck. ALWAYS check your dog’s
neck for signs of skin irritation when using an e-collar. If any signs of
skin irritation are found, suspend e-collar training and consult with a
veterinarian.
Stimulation Reaction
Every dog has a different tolerance level and reaction to e-collar
stimulation. Closely monitor your dog’s reaction to find the right
stimulation level. The stimulation level may vary depending on the
training situation. When highly distracted, dogs will require a higher
level of stimulation.

4 5
Table of Contents
At a Glance………………………………………………………
Main Features of the EDGE………………………………………
Overview…………………………………………………………
Understanding your training system
1. How to turn the EDGE on/off………………………………
2. How the transmitter mode buttons work ……………………
3. Collar tting ………………………………………………
4. How to nd the right stimulation …………………………
5. To maximize the distance …………………………………
6. The LED indicator …………………………………………
7. Charging the battery ………………………………………
8. How to change the stimulation intensity ……………………
9. What the LCD icons mean …………………………………
10. Changing the receiver/collar location light color …………
11. Code Setting ………………………………………………
12. How to change the length of the contact points ……………
13. How to use the test light …………………………………
14. How to change the battery …………………………………
General Training Tips …………………………………………
Maintenance ……………………………………………………
Troubleshooting Guide …………………………………………
Warranty and repair information ………………………………
6
7
8
10
11
13
14
14
15
15
17
19
19
20
21
22
23
27
29
30
32

6 7
At a Glance
- Included in the package -
Transmitter Receiver/Collar Battery charger Splitter cable Test light
Owner’s manual Exchangeable selector dial Contact point extension washer /
adjustment tool
- Optional accessories -
Additional Receivers/Collars with straps
The Dogtra EDGE is expandable to a two, three, or four-dog system.
Field auto charger
Dogtra’s eld auto chargers are designed for use with a 12-volt car
outlet.
European charger
Dogtra’s european chargers are designed for use with a 230V AC
electrical outlet.
To purchase accessories, please visit dogtra’s online store at
shop.dogtra.com or call customer service at 1-888-811-9111.
Main Features of the EDGE
Interchangeable intensity dial
Rheostat/volume style with stimulation levels 1~127
Selector/step style with stimulation levels 1~8
1-mile range
Nick/Constant/non-stimulating Pager vibration modes
Location light with 4 selectable colors
(white, red, blue and green)
User expandable to a two, three, or four-dog system
Replaceable batteries
Fully waterproof
LCD screen
Extendable contact points (5/8” to 3/4”)
Belt clip
2-hour rapid charge batteries

8 9
Overview
EDGE Transmitter
1-dog button On/off button
Rubber-charging cap
Belt clip
Battery cover
2-dog button
3-dog button
4-dog button
LCD
LED indicator
Mode
selection dial
Rheostat/Volume
& Selector/Step
intensity dial
Antenna
EDGE Receiver/Collar
On/off button
LED indicator
Location lights
Rubber-charging cap
Collar strap
Contact points

10 11
Understanding your training system
1. How to turn the EDGE on/o
To turn the transmitter on, hold down the blue button on the back of the
transmitter until the LCD screen illuminates. To turn the transmitter off,
hold down the blue button on the back of the transmitter until the LCD
screen shuts off.
To turn the receiver/collar on, hold down the on/off button until the LED
indicator turns green. To turn the receiver/collar off, hold down the on/
off button until the LED indicator turns red.
2. How the transmitter mode buttons work
Turn the mode selection dial to choose the function, and then press the
button on the front that is set to the desired collar. The single dog EDGE
transmitter comes set to the black button.
N (Nick)
Nick is a single ½ second
stimulation.
P (Pager)
Pager gives a non-stimulating
vibration while the button is
pressed for up to 12 seconds.
C (Constant)
Constant gives a continuous
stimulation while the button is
pressed for up to 12 seconds.
On / Off
Button
On / Off
Button
LED
Indicator

12 13
To activate the light-locate mode, hold down the front transmitter button.
The location light will continuously ash while the button is pressed, up
to 12 seconds.
To activate the light-tracking mode, tap the front button on the
transmitter once.
The receiver/collar LED location lights will now blink every 3 seconds.
To deactivate the light-tracking mode, tap the front button on the
transmitter once more.
3. Collar tting
The collar should be t so that the surgical stainless steel contact points
are pressed rmly against the dog’s skin. With a proper t, you should
be able to insert a nger or two snugly in between the contact points
and your dog’s skin. The best location for the receiver box is on either
side of the dog’s windpipe. The receiver box should stay in this position
during any training or exercise. If the unit slips downward towards the
dog’s windpipe, the unit was NOT fastened rmly enough.
A loose fitting collar can cause the contact points to rub against the
skin and cause irritation. If the collar is on too tight, the dog may have
difculty breathing. ALWAYS check your dog’s neck for signs of skin
irritation when using an e-collar. If any signs of skin irritation are found,
suspend e-collar training and consult with a veterinarian.
L (Light)
High intensity LED location
lights on the EDGE receiver/
collar helps to find and
distinguish dogs easily in low
light/dark conditions.
The buttons on the front of the transmitter enables
control of up to 4 receivers/collars. Each of the 4
buttons on the transmitter can be coded to operate
a different receiver/collar. The receivers/collars can
be distinguished by coding the transmitter button
to the matching receiver/collar strap color.
Additional receivers/collars with straps are
available online at shop.dogtra.com or by calling
customer service at 1-888-811-9111.

14 15
4. How to nd the right stimulation
The EDGE unit comes installed with the rheostat dial on the transmitter.
The rheostat intensity dial controls the stimulation level, with level 1
being the lowest level and level 127 being the highest. Switch to the
included selector style intensity dial with 8 levels of stimulation, with
1 being the lowest level and level 8 being the highest. The level of
stimulation best suited for your dog depends on your dog’s temperament
and threshold for stimulation. Always start at the lowest level and work
your way up. The appropriate level can be found when the dog responds
to the stimulation with a mild reaction, such as a tensing of the neck
muscles. The stimulation level may vary depending on the training
situation. When highly distracted, dogs will require a higher level of
stimulation.
5. To maximize the distance
The Dogtra EDGE has a 1-mile range. The range may vary depending
on the way the transmitter is held. Hold the transmitter away from your
body to receive the greatest range. For maximum signal strength, keep
the Dogtra EDGE properly charged.
*Avoid touching the antenna or the range may decrease substantially.
6. The LED indicator
The LED indicator ashes every 4 seconds when the receiver is on and
ready for use. The LED indicator will blink on both the transmitter and
the receiver when the transmitter buttons are pressed.
The LED indicator color indicates the battery life level.
Green = Fully charged, Amber = Medium, Red = Needs charging
If the unit is used while the LED indicator is red, it will shut down
automatically.
7. Charging the battery
1. Lift the rubber-charging cap and plug in the charger.
2. Plug the adapter’s power plug in to a standard AC wall outlet. The
LED indicator on the transmitter and receiver/collar will turn red.
3. When the unit is fully charged, the LED indicator will turn green on
both the transmitter and receiver/collar. Unplug the adapter’s power
plug from the AC wall outlet and disconnect the charger from the
unit.
4. Place the rubber-charging cap back over the charging port.
Maximum range Typical range Minimum range

16 17
* The transmitter and receiver/collar rubber-charging cap ensures dirt
and debris does not build up in the charging port area. The unit is
waterproof even if the rubber-charging cap is not fully closed.
To charge multiple receivers/collars and a transmitter, combine
additional battery charger splitter cables as shown.
* Warning
1. Fully charge the unit before the rst use.
2. Do not charge the unit near any ammable substances.
3. Fully charge the unit before storing for one month or longer.
4. Always use Dogtra approved charging adapters. When the wrong
charging adapter is used, the LED indicator will not turn on or blink
amber.
8. How to change the stimulation intensity
The Dogtra EDGE has the ability to switch between the rheostat/volume
intensity and the selector/step intensity.
The EDGE unit comes installed with the rheostat dial knob in place. To
switch to the selector/step dial, follow the steps below.
1. Turn the stimulation level to 0.
2. Unscrew the top of the dial with a flathead screwdriver counter-
clockwise.
3. Remove the current dial knob and replace with the desired intensity
dial type.
4. While firmly holding the dial knob in place, tighten the screw
clockwise.
Next, change the program setting to the corresponding intensity dial
type.