Dolphin DOLXMWIHIDEM User manual

1] Overview
2] Installation
3] Wiring Guide
4] Functions Table
DOLXMWIHIDEM Reader/Keypad
USER MANUAL
VIDEO
INSTRUCTIONAL
V.8.1.18

1 Overview
The DOLXMWIHIDEM is a Wiegand output keypad with an
integrated proximity reader. The keypad is digital with built-in
Light Dependent Resistor (LDR) sensor for anti-tamper. Because
the keypad is IP66 rated, it can be mounted indoor or outdoor.
NOTE: The anti-tamper photo eye is on the back of the unit. It
must be covered to not alarm.
Frequency 125KHz
Card Type EM & HID® Cards/FOBS
Read Range 4-8 cm
Standby Current <35mA
Operating Voltage 9-18VDC
Wiegand Ouput Format Wiegand 26 bit (factory default)
Keypad Transmission Format 4 bits (factory default)
Operating Temperature -40°C ~ 60°C
Operating Humidity 0% RH ~ 96% RH
Color Black
Index of Protection IP 66
Dimensions 4-3/4” (L) x 2” (W) x 13/16” (D) inches
Net Weight 150 g
Shipment Weight 200 g
SPECIFICATIONS
PACKING LIST
DOLXMWIHIDEM Reader 1
Manual 1
Screw Driver 1
Wall Fixing Plus 2
Self Tapping Screws 2

2 Installation
Step3
Step2 Step1
Wall
A
C
B
9.5mm
41.5mm
70mm
9.5mm
φ9mm
φ3.2mm
φ5X4mm
• Drill 2 holes (A ,C) on the wall for the screws and one hole (B)
for the cable
• Knock the supplied rubber bungs to the screw holes (A ,C)
• Fix the back cover firmly on the wall with 2 screws
• Thread the cable through the cable hole (B)
• Attach the unit to the back cover

3 Wiring Guide
Wire Color Function Notes
Red Power + +DC (9-18 VDC)
Black GND Ground
Green D0 Data 0
White D1 Data 1
Brown LED Green LED Light Control
Yellow Buzzer Buzzer Control
Note: Brown and Yellow wires are optional connections.
+12V
GND
D0
D1
LED
BZ
Access Controller
Red
Black
Green
White
Brown
Yellow
DOLXMWIHIDEM

4 Functions Table
IMPORTANT NOTE:
The keypad output is factory default set at 4 bit burst output.
Upon request, it can be changed, by Transmitter Solutions,
to 10 bit or 8 bit burst output.
Keypad Transmission Format
The keypad will transmit the PIN data when it receives the
key after PIN code.
Facility Code is always “000”.
The PIN code will always be the Wiegand serial number (a 1 to
5 digit number). Numbers eligible are 1 - 65535.
Read Card The LED light will turn Green, and the
buzzer will beep, the reader outputs the
Wiegand signal
External LED Control When the input voltage for the LED is
low, the LED will turn Green
External Buzzer Control When the input voltage for the Buzzer is
low, the Buzzer will sound
Wiegand Data Output Wiegand 26~37 bits range available for
DOLXMWIHIDEM reader, factory default
setting is Wiegand 26 bits, HID® card
can output Wiegand 26~37 automatically,
EM and Mifare cards are forced to output
based on the reader setting.
#

TRANSMITTER SOLUTIONS WARRANTY
The warranty period of Transmitter Solutions keypad is twenty-four (24)
months. This warranty shall begin on the date the keypad is manufac-
tured. During the warranty period, the product will be,repaired or replaced
(at the sole discretion of Transmitter Solutions) if the product does not
operate correctly due to a defective component. This warranty does not
extend to (a) the keypad case, which can be damaged by conditions
outside the control of Transmitter Solutions, or (b) battery life of the
keypad. This warranty is further limited by the following disclaimer of
warranty and liability:
EXCEPT AS SET FORTH ABOVE, TRANSMITTER SOLUTIONS MAKES NO
WARRANTIES REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING
WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICU-
LAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF
TRANSMITTER SOLUTIONS, EXPRESS OR IMPLIED, WITH REGARD TO THE
GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”. TRANSMITTER SOLUTIONS
SELLS THE GOODS TO BUYER ON CONDITION THAT TRANSMITTER SOLUTIONS
WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER
AGREES THAT TRANSMITTER SOLUTIONS SHALL HAVE NO LIABILITY FOR
DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS
EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO
HOLD TRANSMITTER SOLUTIONS HARMLESS FROM ANY CLAIMS BUYER, OR
ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF
THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS
TERMS IN CONSIDERATION OF RECEIVING THE GOODS.

2480 South 3850 West, Suite B
Salt Lake City, UT 84120
[phone] • [phone] fax
www.transmittersolutions.com