Dometic 3316518 User manual

Revision A Form No. 3317464.000 05/22 | ©2022 Dometic Corporation
Programming
Quick Start Guide
THIS QUICK START GUIDE IS INTENDED AS A GUIDE ONLY AND IS NOT INTENDED TO PROVIDE ALL INFORMATION
AND WARNINGS RELATED TO THE PRODUCT. REFER TO YOUR OPERATING AND INSTRUCTION MANUALS FOR
ADDITIONAL IMPORTANT INFORMATION AND WARNINGS, INCLUDING ADDITIONAL SAFETY WARNINGS.
Model For Part Numbers
Power Awning Pro 3316518.XXX, 3316519.XXX, 33117114.XXX, 3317115.XXX, 3316554.XXX, 3316520.XXX
Complete each programming step within four seconds of the previous step to keep the receiver in pairing mode.
Step Operation Audible Alert Awning Movement
1
Turn Power On Beep x1
None
2
Press Le P2 Button x2 Beep x2
None
31
Press Up Button x1 Beep x4 Awning Jogs
42
Press Le P2 Button x1 Beep x1 Awning Jogs
52
Press Up Button x1 Beep x1
None
62
Press Down Button x1
None None
1 When using on 9500 awning, press the DOWN button at step 3 instead of the UP button.
2Steps 4-7 are only applicable to the 9100 awning series.

Step Operation Audible Alert Awning Movement
72
Press Le P2 Button x1 Beep x3 Awning Jogs
8
Set Sensor Dial to “0”
None None
9
Press Le P2 Button x1 Beep x1 Awning Jogs
10
Press Le P2 Button x1 Beep x1
None
11
Press Programming Button x1 Beep x1/Beep x5 Awning Jogs
12
Set Sensor Dial to “5”
None None
13
Press Programming Button x1 Beep x1 Awning Retracts
14
Set Sensor to Desired Level
(adjusting sensitivity can be done
without reprogramming)
To clear memory:
Press P2
(STOP button)
P2
Programming must then be restarted at Step 1.