DORIC VENTUS LOUVRE LOC User manual

1.
Place the Template on the front edge
of the Gallery and ensure the top edge
is pressed hard up against the bottom
of the Handle Trim
2.
Mark out the three hole locations
and drill to 3.5mm
3.
Enlarge the centre hole to 16mm
4.
Remove any burs or swarf
5.
While holding the Housing, rotate
the Snib Key until it stops.
Clockwise for Right-Hand side installs.
Counter-clockwise for Left-Hand side
installs.
6.
Install the Cam into the
rear of the Housing
5
1
2
INSTALLATION GUIDEINSTALLATION GUIDE Head office:
38 Redfern St
Wetherill Park
NSW 2164 Australia
Ph: 1300 132 389
[email protected]
www.doric.com.au
6
3
4

7a.
Ensure that the Plastic Pip is
located in the bottom position
7b.
And the flat portion of the
Snib key is facing downwards.
8.
Screw the housing onto the Gallery, snap
on the Screw Covers, and insert Snib Key
9a.
Insert the Slide Arm into the Gallery
9b.
Ensure the Pip sits in the slot of the Slide Arm
10.
To lock the Slide Arm ready for
transport, rotate the Snib Key
180 degrees
Clockwise for Left-Hand
Counter-Clockwise for Right-Hand
7a
7b
8
10
9a
9b
INSTALLATION GUIDE Head office:
38 Redfern St
Wetherill Park
NSW 2164 Australia
Ph: 1300 132 389
[email protected]
www.doric.com.au