Dosch&Amand DA1432 DECT indePendant Specification sheet

Get Started
1. Place Device close to DECT base station
2. Activate Registration mode of the base station
3. Press Call Button of Device to start the Registration
4. Pay attention to announcements of Voice Assistant
Your private Emergency Call
step 1: Charge Device
DECT indePendant
step 2: Register Device to Base Station
Call Button
Status LED
Loud Speaker
left Side Key
Microphone
Micro USB
right Side Key
Ring LED
indePendant overview
indePendant is your daily assistant with central Call
Button. If you need help, press Call Button and you will be
connected with neighbours or friends. Fall Detection or Smoke
Alarm automatically trigger Help Call.
All activities are conducted by the language assistant.
Phone book (10 entries) with list of names is read.
2
step 3: check telephone connection
Device is ready to use
5
1. Call Device with your mobile phone
2. If Device rings, answer the call
Note: The calling number is stored as the tenth
Family&Friends number as well as the emergency number
for help, fall detection and smoke alarm calls.
Change or supplement this number with the PC APP.
14
3
1. Place Charging Disc on a flat, non-slip surface
2. Connect the Charging Disc mains via supplied USB cable
3. Place Device for approx. 30 min on Charging Disc
Note: Device will get a little warm; this is normal
SET-into-OPERATION
now you can
- receive phone calls
- call phone number (see Family & Friends)
- execute a Help Call
following features are enabled:
- Fall Detection with automatic help call
- Smoke alarm call
_____________________________________
You can configure via PC APP:
- all contacts for emergency (help, fall, smoke alarm)
- more Family & Friends contacts
- Time and Reminder Messages
Congratulations

Product Information
Title indePendant
Type DECT PENDANT
Charging : Make sure that Device is correctly placed on
Charging Disc. LED indicates battery level status during
charging. Note that Device cannot be registered, if battery is
not sufficiently charged.
Registration: Please keep in mind that DECT base stations
exit Registration mode automatically after 5 min.
Use PC APP to register Device, if PIN of the base station is
not '0000'.
Trigger Help Call: Select and test “Ringing Time" in order to
ensure, that the called party has sufficient time to answer
the call. The ringing time should not be too long in order to
not delay the call of the subsequent numbers . Better
choose more repetitions in order to find a contact quickly
and safely.
Call Family & Friends
For more information please contact your distributor or visit his website
trigger Help Call
1. Connect enclosed USB stick to PC
2. Select „INDEPENDANT“ with WIN Explorer
3. Start „PC_APP" program and if necessary, confirm the
driver installation
4. Connect Device via USB cable to PC
5. Start "PC_APP“ program again and follow instructions of
PC APP which are very simple
Color Display Status LED Ring LED
RED
flashes DECT or Battery
out of range / order Help Call is setup
constant charge ca. 60 min Help Call is active
YELLOW
flashes DECT or Battery
sufficient
- DECT Registration
- Fall Detection active
constant charge ca. 30 min connected with PC APP
GREEN
flashes DECT or Battery
OK
Family&Frriends Call
is setup
constant Battery is fully
charged
Family&Friends Call
is active
LEDs
Tips
start PC APP
6
107
8
9
11
1. Press Call Button > 2 sec
2. Help Call Sequence is starting
3. To cancel Call Sequence press Call Button again
1. Press side key to select wanted number (name)
2. Press Call Button to trigger call
3. To cancel call press Call Button again
CONFIGURATION
Test Device functions
You will find more up-to-date operating instructions on enclosed USB-stick
or on your distributor’s website