Dream On Me 388 Use and care manual

FOLD
1
2
3
SLEEPER
MANUAL INSTRUCTIONS

When using the , never place the product near ed es of
counter tops, table, or other hi surfaces.
Never allow to be used as a toy.
To clean use only mil household soap or detergent and warm water on
a sponge or clean c th.
Check your for loose screws, worn parts, torn material or
sti ching on a regular basis. Replace or repair parts as needed.
Discontinue use of the should it malfunction or become
damaged or broken. Please contact for repair or obtain
replacement parts.
dult supervision is necessary
The minimum range required for this item is around 1 square meter
bedside sleeper is designed to provide a sleeping area for an infant
until he or she begins to push up on hands and knees or approximately 5
months of age. Move your child to another sleeping product when your
child reaches this stage.
Always read and follow assembly instructions for ach product use (
sleeper bassinet).
Always use ALL required parts for each use .
Check instruction manual for a list of required parts. check
product for loose, damaged, or missing parts.
DO NOT use bedside sleeper if any parts are missing, damaged, or
broken. Contact for replacement parts and instruction if
needed. DO NOT substitute parts.
Keep instructions for future use.
Always read and follow assembly instructions for each product use
Assemble product according to manufacturer’s instructions for ANY
use
If a sheet is used with the pad, only the one provided by
or one specifically designed to fit the dimension of the
bassinet mattress.
Please follow all of these instructions to ensure the safety of your child.
Failure o follow these instructions could result in serious injury or death.
Retain these instructions fo future reference.
leave child unattended, allowing your child near the
Keep fingers(yours and baby’s)away from hinges when opening or closing
the . Be certain the is locked in the open position before
allowing your child near the .
Strings can cause strangulation! Do not place items with a string around a
child’s neck, such as hood strings or pacifier cords. Do no suspend strings
over a bassinet or attach strings to toys.
Failure to follow these warnings and the instructions could in
serious injury or death.
FALL HAZARD — To help prevent falls, do not use when
the infant be ins to push up on hands and knees has reached 10lbs
or approximately 5 months , whichever comes first.
Infants have suffocated:
!
!
!

!
1
4
!
To avoid from the
infant’s neck caught on the
top rail on the side that is
next to the adult ,
the top rail must be no
higher than the adult bed
mattress.
Make sure the removable
side is locked when it is no
longer attached to the adult
bed.
— To prevent death from
entrapment, sleeper must be properly secured to
adult bed using the attachment system.
There must be no more than 13mm gap between
bedside sleeper and adult bed. GAP
Notice for using attachment
system.
Fasten the belts and put the
box spring back.
!
!
!
This sleeper is esigned for use only with adult beds that are
between 17.2 and 22.4 inches from floor to top of adult mattress.
Mattress box spring and bed frame share the same width.
The product cannot attach to the adult
bed frame is bigger than the
box pring.
17.2 - 22.4 inches
THE TOP RAIL LOWER THAN THE
ADULT BED MATTRESS.
THE TOP RAIL HIGHER THAN THE
ADULT BED MATTRESS.
The bedside sleeper must be properly
secured to adult bed by tightening the
safety belt.
UNACCEPTABLE BED TYPE TOO FAR
TIGHT AND SAFE
!

FOLD
1
2
3
To Open The :
Put the on a flat platform.
2. Lift the two
legs and push
them to vertical
position.
3. Check and make sure
the two metal pins
work. Then the is
fixed. Turn over ut
the mattress in
osquito net
rame
asket
attress
utton for
adjusting height
utton for folding

button for adjusting
height
in use
To Use The :
button for folding
To Fold The Co :
1. Adjust to
the “FOLD” position, i.e., the
lowest position. Check see
the mark “FOLD” on both
sides. Then, turn over the cot
and put
2. Put the legs
down while pressing
the two buttons for
folding.
3. Put the
base in the center of the frame,
and insert lower pair of the
cot feet between the frame and
cot base. Then, it is folded
completely pair of feet
beneath the frame