Dretec T-580 User manual

MADE IN CHINA
T-580
MS
HM S
D
P
A
<Left side><Front side>
<Right side>
<Rear side>
Battery cover
Alarm selection switch
MODE button
HOUR/UP button
SEC/SET/12/24 button
LED lamp
Strap hole
Display
START/STOP button
Counts and pauses in the
timer mode. Switches from
clock, timer (hour),
timer (minute), and
day count.
Changes the alarm
sounding time.
Approx. 15 seconds
Approx. 1 second
No alarm
(only LED blinking)
Locks all the buttons.
Locked Unlocked
Timer mode: Sets the hour.
Calendar mode/Time setting
mode: Increases the number.
Timer mode: Sets the second.
Clock mode: Selects time
display.
Calendar mode/Time setting
mode: Determines the item.
* Pressing the [MIN] and [SEC]
buttons simultaneously resets
the display.
Lock switch
- 1 - - 2 -
* The LED blinks for
approx. 15 sec. for any
alarm sounding time.
MIN/DOWN button
Timer mode: Sets the minute.
Calendar mode/Time setting
mode: Decreases the number.
Instruction Manual
Thank you for purchasing our product. Be sure to read this instruction
manual thoroughly before use, and use this product in a safe and
correct manner. After reading this manual, keep it at hand with care to
make it possible to see it at any time.
22-04
Safety Precautions
●Be sure to read this “Safety Precautions” carefully before use
and use the product in a correct manner.
●The precautions described herein are matters about safety,
and therefore, be sure to observe them.
Time Up 2
T-580/T-587
Matters must not to be done
Prohibition
Instruction
Matters must be done
Warning
Prohibition
Instruction
●Never disassemble, repair, or remodel the product.
Failure to observe this may cause ignition, electric shock, or
injury.
●Do not leave the product within the reach of an infant
and a person who cannot operate it by him/herself.
Failure to observe this may cause accidental swallowing or
injury.
● If an abnormality or a failure is observed, stop using the
product immediately.
Failure to observe this may cause ignition, electric shock, or
injury.
Importer / Contact: SUNSATA
Phone: [phone]
Manufacturer: dretec
Address: 2-3-9 Ryutsudanchi Koshigayashi Saitama
About Battery
● Do not short-circuit the batteries, do not disassemble or heat the
batteries, and do not throw the batteries into fire.
● If your skin or clothing comes into contact with the battery liquid,
wash it away with water completely. If your eye comes into
contact with it, wash it away with clean water and then see a
doctor as soon as possible.
● Do not leave the batteries within the reach of an infant. In case a
battery is swallowed, see a doctor as soon as possible.
● Pay attention to the polarities (+/-) of the batteries and put them
in the product in a correct manner.
● When the batteries are exhausted or the product is not used for
a long period of time, remove the batteries.
● When you dispose of the batteries, follow the local instructions.
● Do not use an old battery with a new battery in a mixed manner.
● If an unprecedented difference such as heat generation from the
batteries or battery deformation is observed when the product is
used or stored, stop using it.
Caution
Prohibition
Instruction
●Do not apply a strong impact to the product for
example by dropping it or bumping it.
●Do not store or use the product in a damp place or a
water splashing place because the product is not
waterproof or dripproof.
Failure to observe this may cause a failure.
●Do not leave this product in a place where direct
sunlight hits or the temperature becomes hot.
●Do not apply fire to the product directly or put it near
fire.
●Do not put solvents or chemical solutions on the
product.
Failure to observe this may cause the main unit to be
deformed, which results in a failure.
● Install the product on a horizontal and stable place.
● When the product is carried, refrain from using it close
to a device that generates static electricity such as a
pacemaker or electromagnetic waves such as a
microwave oven, and an IH cooker.
Failure to observe this may cause a failure or a malfunction.
Names of Each Part
●When the battery capacity is consumed, the display becomes lighter and a
malfunction may occur. Replace the batteries according to the following
procedure:
1. Open the battery cover on the rear side.
2. Remove the old batteries, and put new batteries in the product.
* Be careful with the polarities (+/-) of the batteries when putting batteries in
the product.
3. Close the battery cover.
Battery Replacement

HM S
1. Keep pressing [SET] button for more than 3 seconds.
* 2018(Year) is going to flash.
● Before using, please remove the insulation sheet from the battery cover. When
the insulation sheet is pulled out, there will be “pipipipi” sound and with
“2018” flashing afterwards.
* when first time using or replacing the batteries, please follow the below settings(start
from step 2).
3. Press [SET] button for confirmation.
* “Month” is going to flash.
5. Press [SET] button for confirmation.
* “Day” is going to flash.
2. Press [UP] or [DOWN] button to set “Year.”
* Keep pressing the button for digit fast forward (2018
- 2050 can be set)
4. Press [UP] or [DOWN] button to set “Month.”
* Keep pressing the button for digit fast forward.
7. Press [SET] button for confirmation.
* The [Hour] of [Hour:Minute:Second] is going to flash.
6. Press [UP] or [DOWN] button to set “Day.”
* Keep pressing the button for digit fast forward.
9. Press [SET] button for confirmation.
* The “Minute” of “Hour:Minute:Second” is going to flash.
* Changing the display: while in clock mode, press [12/24] button to switch between
AM/PM and 24 hour display.
8. Press [UP] or [DOWN] button to set “Hour.”
* Keep pressing the button for digit fast forward.
* The default setting is 24 hours display.
10.Press [UP] or [DOWN] button to set “Minute.”
* Keep pressing the button for digit fast forward.
11.Press [SET] button to confirm and finish the setting,
then the clock begin from 00 second.
Calendar/Clock setting
Counting down/counting up function
<24 Hour display> <AM/PM display>
P
■Counting down
<Display of timer mode (hour)>
MS
<Display of timer mode (minute)>
Date counting down
1. Press [MODE] button to enter date counting down
mode.
2. Keep pressing [SET] button for more than 3 seconds.
* 2018 is going to flash.
4. Press [SET] button for confirmation.
* “Month” is going to flash.
6. Press [SET] button for confirmation.
* “Day” is going to flash.
3. Press [UP] or [DOWN] button to set “Year.”
* Keep pressing the button for fast forward. (Display range between 2018 - 2050, the
maximum date counting down is 9999 days)
7. Press [UP] or [DOWN] button to set
“day.”
* Keep pressing the button for fast forward.
8. Press [SET] button for confirmation.
* Display with the days remaining dated
from the date of counting down setting.
● In case if there is no operation for more than 20 seconds during setting process, the
previous setting will be recovered automatically.
● Keep pressing [SET] button for more than 3 seconds to clear the current counting
down setting while in date counting down mode.
* The date counting down will be automatically cleared after replacement of the battery,
please set again.
● Days remaining dated from the date of counting down setting.
* Please make sure the calendar/clock setting are correct.
Example: Setting to
a year later
<Day count mode>
- 3 - - 4 - - 5 -
5. Press [UP] or [DOWN] button to set “Month.”
* Keep pressing the button for fast forward.
HM S
<Display of timer mode (hour)>
MS
<Display of timer mode (minute)>
6. When time is up, the alarm start to ring and indicator start to flash at the
same time.
* Alarming time setting (Around 15 seconds/Around 1 second/No alarm) the
indicator flash 15 seconds in any setting.
* Press any button to stop the alarm/flash. When alarm/flash stopped, it return to
the previous time setting automatically.
●When counting down is paused, press [SET] button to return to the previous time
setting.
How to Clean
When the main unit becomes dirty, wipe the unit with a tightly squeezed wet
cloth.
● If the unit becomes heavily dirty, wipe the unit with a cloth containing a little
of a neutral detergent for kitchen use.
● Do not use boiling water, alcohol, thinner, benzine, and the like.
Failure to observe this may cause discoloration, deformation, and breakage.
● Never wash the product in water.
Do not splash water directly on the product, and do not let the product
contact with detergents. Failure to observe this may cause a failure.
“The power cannot be turned on”
○ Are the batteries exhausted?
○ Are the polarities (+/-) of the batteries correct?
○ Is the insulation sheet removed?
“The display becomes lighter”
○ The batteries are exhausted. Replace both of the two batteries with new
ones.
“The product does not start/The count does not stop/Buttons are
inoperable”
○ Press the “START/STOP” button fully and securely.
○ Is the lock switch set to Lock On?
“No sound is produced”
○ Check the alarm selection switch.
Before concluding the matter is a failure
Specifications
1. Press [MODE] button to enter timer mode.
2. Press [MIN], [SEC] button at the same time to
clear the display.
3. Press [HOUR], [MIN], [SEC] button to set the
timer.
* Keep pressing the button for digit fast forward..
* Clear the display when the time setting exceeded,
and set again.
4. Press [START/STOP] button to start counting down.
* Please make sure to press the button to the bottom.
5. Press [START/STOP] button to pause during counting down.
Press [START/STOP] button again to continue counting down.
■Counting up
1. Press [MODE] button to enter timer mode.
2. Press [MIN] and [SEC] button at the same time
to clear the display.
3. Press [START/STOP] button to start counting
up.
* Please make sure to press the button to the
bottom.
4. Press [START/STOP] button to pause during
counting up.
Press [START/STOP] button again to continue
counting up.
Display method Liquid crystal digital, 7 digits
Operating
temperature range 0 to 40○C
Battery AAA dry battery x 2 pcs.
(batteries for operation check supplied)
Battery life Approx. 1 year
(when an alarm is issued for 15 seconds 2 times in a day)
Timer (minute)
Max. settable time 199 minutes 59 seconds
Max. display time for counting up 199 minutes 59 seconds 99
Timer (hour)
Max. settable time 199 hours 59 minutes 59 seconds
Max. display time for counting up 199 hours 59 minutes 59 seconds
Calendar/
Clock display
Calendar settable range 2018 to 2050
Clock accuracy Monthly rate: ±60 seconds
Max. settable daysDay count 9999 days
* Be aware that the specifications of the product are subject to change without notice
due to product improvement.