Drive Medical 12005KD Administrator Guide

How to assemble and adjust the 12005KD
1. Verify that all the parts are present.
2. Remove the protective caps off the leg receivers.

3. Install each leg into the receiver by depressing the locking pin and sliding the
leg into the receiver. Make sure the locking pin engage into the receiver. Install
the inner legs into leg receivers in the side of the base with two cushions on it.
Install the outer legs into leg receivers in the side of the base with one cushion on
it.

4. Determine which side of the transfer bench will be facing towards the rear of
the tub. Slide one of the backrest brackets into the bracket under the seat on the
side of the transfer bench that will be facing the rear of the tub. Make sure the
back rest locking buttons are facing each other. Make sure the locking button is
engaged. Repeat this for the other bracket.

5. Align the armrest with the armrest brackets and insert. Push both locking
buttons and continue to insert the arm rest until it locks into place.

6. Align the backrest with the backrest brackets and slide the backrest
down. Depress the two locking buttons and continue sliding the back rest down
until the locking buttons engage.
7. Adjust the leg by pushing in the locking button and turning the leg

slightly. Slide the leg to the desired height and turn back until the locking button
snaps into place. Repeat this process for the remaining legs.