Drive Medical Oxygen Pulse Oximeter User manual

888-606-8778
hartmedical.org
COVID-19 Guide
Oxygen Pulse Oximeter
The Drive Pulse Oximeter is used to measure the oxygen level in the blood
with a special photoelectric sensor that is painless and simple to use.
Important information you should know:
•Uses 2 AAA batteries
•Do not stare at the infrared light in the oximeter
•Not intended for use on children 4 years and younger
•Nail must be polish free
•Nail must be short
Instructions:
•Insert the two batteries properly to the direction, and then replace
the cover.
•Open the clip.
•Put the user’s finger into the rubber cushions of the clip with the
fingernail towards the top.
•Clip the finger as shown in the picture.
•Press the switch button once on front panel.
•Do not shake the finger and remain at ease during the process.
•Moving is not recommended during this process.
•Review the information directly from screen display.
•Record the % SpO2 number.
•The pulse oximeter will power off automatically within 5 seconds
after removing your finger.
COVID-19 Monitoring Guide: Remember to write down all % SpO2 (oxygen sat) results
1. Always follow your doctor’s instructions when different than these outlined below.
2. Check oxygen saturation every 2 hours while awake.
3. If % SpO2 is less than 92% follow instructions from your doctor, or call your doctor.
4. Beginning on day 4 of oxygen therapy, check % SpO2 on room air, not using oxygen.
5. If result is less than 90%, continue using oxygen, and repeat test the next day
6. If result is 91% or higher, walk inside home or room for 1-2 minutes without oxygen, and then retest.
•If result is 90% or lower, continue using oxygen, and repeat the test the next day.
•If result is 91% or higher, stop using oxygen, and test oxygen level every 2 hours for 12 hours, and
record time and results.
•If any result is 90% or less, continue using oxygen, and repeat testing –step #6 the next day.
•If oxygen level remains at 91% or higher, stop using oxygen, and call Hart Medical Equipment to
pick-up the oxygen. Hart Medical Equipment will request your testing results and send a notice to
your doctor.
•Hart will contact you about a pick-up of your oxygen equipment and pulse oximeter after
confirming with your doctor.

888-606-8778
hartmedical.org
Pulse Oximetry Log
DAY
Test Results
Test Results
Test Results
Test Results
Test Results
Test Results
1
2
3
4
Follow instructions below
5
Follow instructions below
6
Follow instructions below
7
Follow instructions below
8
Follow instructions below
9
Follow instructions below
10
Follow instructions below
11
Follow instructions below
12
Follow instructions below
Instructions:
1. If SpO2 90% or less, follow instruction from doctor or call your doctor.
2. If SpO2 91% or higher, follow these directions:
•Walk inside home or room for 1-2 minutes without oxygen, and then retest.
•If result is 90% or lower, continuing using oxygen and repeat the test the next day.
•If result is 91% or higher, stop using oxygen and test oxygen level every 2 hours for 12 hours
and record time & results.
•If any result is 90% or less, continue using oxygen and repeat this entire testing procedure the
next day.
•If oxygen level remains at 91% or higher, stop using oxygen and call Hart Medical Equipment
to pick-up the oxygen. Hart Medical Equipment will request your testing results and send a
notice to your doctor.
•Hart will contact you about a pick-up of your oxygen equipment after confirming with your
doctor.