Drive 15560 User manual

1
Owner’s Assembly And Operating Manual
Ultra Light Plus, Semi Electric Bed
Competitor
Item # 15560, 15560-HR
Note: The competitor bed is available with half-rails (not shown).
See page 16 for installation instructions.

2
REV4.3.5.14
1. Remove contents from carton.
Assembly Instructions
2. Placebothendsofthesleepsurfaceontheirsideandaligntheangewiththereceptacleasshown.
3. Toattachtheheadandfootspring,pulltheblackknobawayfortheframeandslidethetwosides
 together.Thelockknobisspringloadedandwilllockintopositionwhenreleasedandthetwosections
 ofthebedareushtogether.
To disassemble the head and foot section, pull the black lock knob out and rotate the knob a quarter turn.
Thelockknobwillremainopentoallowtheheadsectiontoberemovedfromthefootsection.

3
Assembly Instructions Cont.
4. Securethesleepsurfacewiththecotterpinasshown.
5. Lockthecotterpinwiththeattachedclasp.Repeatontheoppositeside.

4
REV4.3.5.14
Assembly Instructions Cont.
6. NOTE:Beforeinstallingmotor,plughandpendantcableintomotorasshown
7. To install motor, remove locking caps on top of the motor.
HAND CONTROL
TheCompetitorbedcomeswithahandcontrolthatwill
illuminatewhenthebedispluggedintoagroundedor
polarizedwalloutlet,orwith9Vbattery(notincluded)
installedinthehandcontrol.Thehandcontrolwill
illuminateaslongasthewallorbatteryhaspower.With
thisbatteryinstalled,themotorcanbeoperatedtoreturn
the sleep surface to the horizontal position in the event of
apowerfailure.

5
Assembly Instructions Cont.
There are two methods for the installation of
the motor
Method A
Themotorisinstalledonthebedframewhentheframeisstanding
on its side.
Installation instructions can be found on pages 7-8.
Method B
The motor is installed from underneath the bed frame
(horizontaltotheground)
Installation instructions can be found on pages 10-11.

6
REV4.3.5.14
Assembly Instructions Cont.
A2. Align the opening on the head end of the
 motorwiththeangeontheheadsectionof
 thebedandinserttheangeintothemotor
compartment.
Actuator Bar
Flange
A3. Withthepalmofyourhand,snapthemotor
 ushtotheactuatorbar.
A4. Align the opening on the foot end of the
 motorwiththeangeonthefootsectionof
 thebedandinserttheangeintothemotor
compartment.
Method A
Installation of the motor when bed frame is on its side
A1. Priortoinstallation,makesurethatthe2whitemotorblocksareintheretractedposition.
CORRECT INCORRECT
A5. Withthepalmofyourhand,snapthemotor
 ushtotheactuatorbar.

7
A6. Once in place, replace the motor covers to secure the motor.
A6.Oncethemotorisattached,laybedatandinstallheadandfootboards.Thereare2height
adjustments on the head and foot board. Select the desired positions and hook the frame onto the foot
board.Slidelocktowardslegoffootboardtosecurepositionasshown.Repeatforoppositeside.
Assembly Instructions Cont.
Slide Lock
HEIGHT ADJUSTMENT
9. TheCompetitorbeddeckhastwoheightadjustments.
10. Adjustmentoneislocatedontheframeasindicatedbelow.Thereisahighpositionandalowposition.
11. Adjustmenttwoisonthelegoftheheadandfootboard.Toadjust,loosenthethumbscrewontheleg
andpullonthespringloadedknobwithonehandandslidethelegtothedesiredheightwiththeotherhand.
Oncethedesiredpositionisfound,turnthethumbscrewuntiltight.Adjustotherlegstothesameposition.

8
REV4.3.5.14
Assembly Instructions Cont.
End Method A
Thechartbelowindicatestheheightadjustmentsastheyrelatetothetwoadjustmentoptions.
*Rails cannot be used at this height.
Deck Height Pins
Leg Holes
Upper
Lower
1- High
1- Medium
1-Low
Deck Height (inches) Deck Height Pins Leg Hole Wheels
 11* Lower Low No
 13.125 Upper Low No
 14 Lower Low Yes
 14.152 Lower Middle No
 16.125 Upper Low Yes
16.25 Upper Middle No
 17.152 Lower Middle Yes
 17.875 Lower High No
 19.25 Upper Middle Yes
20 Upper High No
 20.875 Lower High Yes
 23 Upper High Yes

9
End Method A
Method B
Installation of the motor from underneath the frame
B2. Repeat for the other side.
Assembly Instructions Cont.
Deck Height Pins
Leg Holes
Upper
Lower
1- High
1- Medium
1-Low
B1. Attached head a foot board to frame.

10
REV4.3.5.14
Assembly Instructions Cont.
B4.Removethecoversfromthemotorandplaceunderthebedandalignedwiththeactuatorunderthehead
section. There are labels on the motor that provide direction and placement in relation to the head section.
B5.Withbothhands,liftthemotorandinsertintotheactuatorandframeasshown.Withthepalmofyour
handsnapthemotorushtoactuatorbar.
B3. Priortoinstallation,makesurethatthe2whitemotorblocksareintheretractedposition.
CORRECT INCORRECT