Drive 11120SV-1 User manual

upholstered, wheeled
drop arm commode
www.drivemedical.com
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
EU Authorized Representative
Drive International, LLC
Globe Lane - Stockport
DUKINFIELD SK16 4RE, GB

1. Before assembling seat, allow toilet seat to reach
room temperature if exposed to cold. This will help
prevent the seat clamps from cracking while being
assembled onto commode back cross brace.
2. Insert Back support into frame.
3. To drop arm, depress release button on arm and
gently allow to drop until reaching arm stop.
4. Align the toilet seat clamps onto the back frame rail.
(Both clamps should sit outside the pail brackets).
Push down on seat until clamps snap firmly
into place.
5. When removing the seat grasp the back of the seat
and lift.
6. Install commode bucket by placing in bucket frame.
Reverse to remove.
1. Toilet seat must be in down position before use. Failure
to do so may result in breakage of commode and
possible injury.
2. Do NOT install commode without first reading and
understanding this assembly and instruction sheet. If
you can not understand these instructions, contact a
healthcare, dealer or technical professional before
attempting to install. Otherwise, injury or damage
may occur.
3. Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE.
Contact dealer/carrier for further instructions.
4. Ensure ALL screws, nuts and/or bolts are tightened.
5. Users with limited physical strength should be supervised
or assisted while using commode.
FIGURE 1
Bucket
Frame
Back
Support
Release
Button
Arm
Bucket
commode assembly
instructions and precautions
assembling commode
additional precautions