Dual MXDMA80 Operating instructions

INSTALLATION/OWNER’S MANUAL
CD/MP3/iPod Ready Weather Receiver with Detach Face
MXDMA80
MARINE

2
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove trim ring from unit,
• Remove 2 transit screws located
on top of the unit.
• Insert the supplied keys into the
slots as shown, and slide the unit
out of the mounting sleeve.
• Install mounting sleeve into
opening, bending tabs to secure.
• Connect wiring harness and
antenna. Consult a qualified
technician if you are unsure.
• Test for correct operation and slide
into mounting sleeve to secure.
• Snap trim ring into place.
• Mount the iplug™ adapter to any
smooth clean surface using the
supplied double-sided tape or #2 x
3/8” Phillips head screws.
MXDMA80 INSTALLATION
Preparation

3
FUSE
When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The MXDMA80 uses one
10 amp ATM fuse located
beside the wiring connector.
MXDMA80 INSTALLATION
Wiring Diagram
MWR30
BLUE
Sub Out
BLACK
Front Preamp Line Out
WHITE
10-pin iPod Connection

4
Tune/Track Down
Eject
Volume/Audio/Setup
AS/PS/Enter/Function
Tune/Track Up
LCD Display
*Key #0/Preset #10
Preset #5/Folder Up
Preset #9/EQ
Preset #4/Folder Down
1
2
3
4
5
6
7
8
9
10
Preset #8/Tuner Scan
Preset #3/Intro
Preset #7/Return
Preset #2/Random
Preset #6/Menu
Preset #1/Repeat
Mode/Shift/Search
Display
Power
Band/Play/Pause
11
12
13
14
15
16
17
18
19
MXDMA80 OPERATION
Control Locations - Receiver
20
19 18 15 16
1 2 5 34
20 71112 89101314 17
The XDM6825 allows playback of your favorite MP3 and WMA files recorded on CD-R and
CD-RW discs. Its powerful on-board DSP processor decodes the compressed audio while
maintaining near-CD sound quality. An internal SRAM buffer provides ESP (Electronic
Skip Protection) to virtually eliminate skipping and allows alphanumeric or direct track
search - even while a song is currently playing!
6

5
The front panel is semi-permanently attached during
assembly. Please refer to the separate yellow instructions
(before installation) to make the front panel removable.
With the unit off, press EJECT to allow the front panel to slide
down. Gently squeeze the release tab located on the bottom
center underside and pull front panel down and away from
unit to remove. To install, insert left side first, then push right
side to secure.
Press PWR for 2 seconds or any other button momentarily
to turn the unit on. Inserting a disc will turn the unit on
automatically. Press PWR for 2 seconds to turn the unit off.
Press MODE to select between tuner, weatherband and
auxiliary input. Modes of operation are indicated in the
display.
Adjust volume using rotary encoder (00-46).
Press EQ to select between POP, JAZZ, CLASSIC, BEAT,
ROCK and OFF (default) equalization curves. Any adjustment
to the Bass or Treble settings automatically cancels the
current EQ curve (if one is selected).
When in AM/FM, CD, WB or AUX mode:
Press DISP to select between clock and radio frequency
(tuner mode), clock and CD elapsed time/track (CD mode),
clock and WB frequency mode or clock and AUX (AUX mode).
Press DISP to select between channel name, artist name,
song title or clock.
With the unit on, press and hold DISP until the clock begins to
flash, then release. Press TUNE
nn
to adjust the hours and
TUNE
ll
to adjust the minutes. Press DISP momentarily to
save the selected time.
Front Panel Note:
Front Panel Removal
Power On/Off
Mode
Volume
Preset EQ Curves
Display
Set the Clock
MXDMA80 OPERATION
General Operation

6
MXDMA80 OPERATION
General Operation - Setup Menu
12/24-hour Clock
Setup Menu
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
Press and hold the rotary encoder for more than 3 seconds
to access the setup menu. Press the rotary encoder
momentarily to select between the menu functions and
rotate the rotary encoder left/right to adjust or activate the
desired function.
Menu Function Options Action
Loudness Curve LOUD OFF Disables the loudness function.
LOUD ON Enables the loudness function. Activating
this feature will enhance the bass and treble
frequencies when listening to music at low
volumes.
Tuner Frequency
Spacing
FREQ USA Programs the unit to USA tuner spacing.
(200kHz for FM and 10kHz for AM)
FREQ EUR Programs the unit to European tuner spacing.
(50kHz for FM and 9kHz for AM)
Clock Display CLK OFF Programs the unit to not display the clock when the
power is off.
CLK ON Programs the unit to display the clock when the
power is off.
Auxiliary Mode AUX ON Enables access to auxiliary mode.
AUX OFF Disables access to auxiliary mode.
Beep
Confirmation
BEEP OFF Disables the confirmation beep.
BEEP ON Enables the confirmation beep.
Local/Distance
Tuning
LOC OFF Activates Distance tuning.
LOC ON Activates Local tuning for strong station reception
only.
Subwoofer SB-W ON Enables sub to be adjusted, 00 - 12
SB-W OFF Disables sub.
Power on
Message
MSG ON Enables power on message to be displayed.
MSG OFF Disables power on message.
Demo
Message
MSG ON Enables message to be displayed.
MSG OFF Disables message.

7
Press rotary encoder momentarily to select between
Volume (default), Bass, Treble, Balance, Fader & Subwoofer.
Press rotary encoder until BAS appears then rotate encoder
left/right to adjust ( -6 minimum / +6 maximum).
Press rotary encoder until TRE appears then rotate encoder
left/right to adjust ( -6 minimum / +6 maximum).
Press rotary encoder until BAL appears then rotate encoder
left/right to adjust (BAL L 12-BAL 00-BAL R 12).
BAL 00 represents equal balance
Press rotary encoder until FAD appears then rotate encoder
left/right to adjust (FAD F 12-FAD 00-FAD R 12).
FAD 00 represents equal fader
Press AUDIO until SUB appears then rotate encoder
left/right to adjust ( SUB 00 - SUB 12 ).
Note: In setup menu, must show: SB-W ON
Individual Bass and Treble settings are retained in memory
for AM, FM, CD, AUX, WB and iPod modes. This allows you
to save the Bass and Treble settings separately for each
mode.
Note:
Any adjustment to the Bass or Treble settings automatically
cancels the current EQ curve (if one is selected).
Press RESET upon initial installation or if abnormal
operation occurs. The reset button is located behind the
faceplate.
Audio
Bass
Treble
Balance
Fader
Subwoofer
Source Audio Memory
Reset
MXDMA80 OPERATION
General Operation
BASSVOLUME TREBLE BALANCE FADER SUBWOOFER

8
Seek Tuning
Manual Tuning
Scan Tuning
Band
Storing and Recalling
Station Presets
Automatically Store
Stations
Preset Scan
Press TUNE
nn
or TUNE
ll
momentarily to seek the
next strong station.
Press TUNE
nn
or TUNE
ll
for more than 2 seconds,
then release. "MANUAL" will momentarily appear in the
display. Press TUNE
nn
or TUNE
ll
momentarily to
move radio frequency up or down one step at a time. Press
and hold to advance quickly. If tuning is not adjusted for 5
seconds, the unit will return to seek tuning mode (default).
"AUTO" will momentarily appear in the display.
Press SCN to preview strong stations on the current band,
pausing for 5 seconds at each. Press SCN again to cancel.
Press BAND to select between FM1, FM2, FM3, AM1 and
AM2 bands.
Up to 18 FM stations and 12 AM stations can be stored. To
store a station, select the desired band and station. Press
and hold the desired preset button (1-6) for more than
2 seconds. When stored, the preset number will appear in
the display. The station can be recalled anytime by pressing
the corresponding preset button.
Note:
Function keys 7, 8, 9 and 0 apply to MP3/WMA operation
only.
Press AS/PS for more than 2 seconds to automatically store
the six strongest stations in the current band. Automatic
Local tuning is activated during the initial band scan.
Press AS/PS for less than 2 seconds to scan presets 1-6 on
the current band, pausing for 5 seconds at each. Press
AS/PS again to cancel.
MXDMA80 OPERATION
Tuner Operation

9
MXDMA80 OPERATION
Press Mode to select between AM/FM and WB
Press TUNE
nn
or TUNE
ll
momentarily to seek the
next weatherband station.
Press preset 1-7 to directly access the 7 weatherband sta-
tions. Refer to the table below.
Weatherband Tuner Operation
Mode
Manual Tuning
Direct Tuning
Weatherband Stations - Direct Tuning Table
Button WB Frequency LCD Display
Preset 1 162.400 MHz WB 162.400
Preset 2 162.425 MHz WB 162.425
Preset 3 162.450 MHz WB 162.450
Preset 4 162.475 MHz WB 162.475
Preset 5 162.500 MHz WB 162.500
Preset 6 162.525 MHz WB 162.525
Preset 7 162.550 MHz WB 162.550

10
Insert CD
Eject CD
Track Select
Fast Forward and Reverse
Pause
Scan
Repeat
Random
CD-R/CD-RW Compatibility
With the label facing up, insert a standard size CD into the
CD slot. The CD will automatically begin playback.
Press EJECT to eject the CD. The unit will change to
previous mode of operation (AM, FM, WB, or auxiliary input).
If the disc is not removed within 10 seconds, the unit will
reload the disc. The unit does not have to be turned on to
eject CD.
Press TRACK
ll
to skip to the beginning of the next
track. Press TRACK
nn
to return to the beginning of the
current track. Pressing TRACK
nn
again skips to the
beginning of the previous track.
Press and hold TRACK
ll
or TRACK
nn
to fast forward
or reverse a track.
Press
l
/ II to temporarily stop CD playback.
Press
l
/ II again to resume playback.
Press INT to play the first 10 seconds of each track.
Press INT again to cancel.
Press RPT to continuously repeat selected track.
Press RPT again to cancel.
Press RDM to play all tracks in random order. Press RDM
again to cancel. Random mode is retained in memory
when selecting between AM/FM tuner, CD player, WB and
auxiliary input modes and when the unit is turned on/off.
Some CD-Rs and CD-RWs may be incompatible with this
unit, depending on media type and recording method. In
addition, the following CDs may be incompatible with this
unit:
CDs exposed to extreme temperatures or direct sunlight
for extended periods of time, CDs recorded in which a
recording session failed or a re-recording was attempted
and, or encrypted or copy-protected CDs which do not
conform to the audio CD-DA red book recording standard.
MXDMA80 OPERATION
CD Player Operation