Dukane Camera 445 User manual

English - 1
Dukane Camera 445 Visual Presenter
Quick Start Guide
To download the latest version of Quick Start
Guide, multilingual user manual, software, or
driver, etc., please visit
http://www.dukcorp.com/audiovisual/produc
ts
“Downloads”
Dukane Audio Visual, 2900 Dukane Drive
St. Charles, IL 60174
866.280.4298 Fax: [phone]
http://www.dukcorp.com/
090107-Rev 1.1

Englis
h- 3
1. Package Content
DC445
Quick Start Guide
User Manual
Base Installation Guide &
Download Card
Remote control
Remote Control Holder

Extender Adapter
VGA Cable
USB Cable
C-Video Cable
Power Cord
Microscope Adapter
Appearance may vary with
country/region.
Accessory Pouch
Audio cable

Englis
h- 4
2. System Diagram
3. Mounting the Camera 445 on a Desktop Stand.
1. Please set up the DIP Switch settings first. Refer to chapter 5 “DIPSwitch Settings” in the DC265 user manual.
2. Please refer to the Base Installation Guide for installation instructions for all parts in the User Manual.
PC
PC
Projector
Monitor
LCD TV
Speaker
SD Card
Television
PC
Monitor

Englis
h- 5
4. Connecting Devices
4.1 Step 1: Plug in the Power Outlet
<Note> Appearance of power cord may vary with countries/regions.
4.2 Step 2: Connecting the components
4.2.1 Connecting to a Projector
Connect the VGA OUT on the 445 to the VGA IN on the projector using the VGA cable.
4.2.2 Connecting to a Monitor
Connect the VGA PASSTHROUGH on the 445 to the VGA IN on the monitor using the VGA cable.
<Note> The VGA PASSTHROUGH connector only outputs VGA IN signals.
4.2.3 Connecting to a TV
1.Using EXTENDER and C-Video cable to connect EXTENDER of 445 to a C-Video of TV.
2.Adjust DIP Switch Setting
NTSC：America, Taiwan, Panama, Philippine, Canada, Chile, Japan, and Mexico.
PAL：Country/region not listed above:
<Note> OSD is not available in C-Video. Functions such as [Menu] /[Rotate] / [PAN] / [Source] / [Record] / [Capture] / [Delete] / [PBP] / [Slide
Show] are not functional on control panel and the remote control. <Note> VGA output is not supported once C-Video output is enabled.
3.DIP Switch setting will not be available until restarting the Camera 445.
AC Outlet

Englis
h- 6
電腦
Speaker
4. 4.2.4 Connecting to a LCD TV/ PDP
Using the HDMI cable to connect a LCD TV/ PDP
4.2.5 Connecting to a Computer
Connecting to a computer through VGA IN
Connecting to a computer through USB
Connect to USB port then install the supplied queueTM program. Please refer to the Camera 445 user manual
Using the EXTENDER and RS-232 cable to connect EXTENDER of 445 to a RS-232 of computer.
4.2.6 Connecting to Speaker

Englis
h- 7
5. Start Using the Camera 445
5.1 Turn on the DC265
When using the remote control, aim at the receptor on the Camera 445, and press the power button.
Once Camera 445 is turned on, the LED on the control panel will flash a few times and stay lit. Please contact
your distributor if the LED is not on.
<Note> If the password page is shown, please key in the password. If you forget it, please contact your
distributor or the service center.
*For detailed menu function introduction and operation instructions, please refer to the user manual.
Dukane Corporation, Audio Visual Division
2900 Dukane Drive, St. Charles, IL 60174
1.866.280.4298
Fax: [phone]
www.dukcorp.com/av
www.conveyclassrooms.com
For 24-Hour Support call: 1.800.676.2487