Dunelm Anya User manual

INSTRUCTIONS
www.dunelm.com
www.dunelm.com
Anya Dining Bench

Ref Visual Qty Dimensions
1
2
1
2
Fixtures and fittings supplied (actual size)
10
mm 20 30 40
4
AM6 x 12mm
Ref QtyDimensions
4
B
C
ø18mm
1
AM8 x 25mm
Ref QtyDimensions
1
B
C
D
E
ø14mm
ø25mm
ø30mm
Dear Customer
Check the pack and make sure you have all the parts listed below. If not, contact
the helpline on 03451 656565 who will be able to help you
Safety advice
IMPORTANT - The first step you need to take is to ensure your safety! Please take the
time to read and understand these instructions before assembling your furniture.
Ensure that all packaging is disposed of carefully and responsibly.
Please keep these instructions for future reference.
Keep children and animals away from the assembly area. This furniture contains small
parts that could cause choking if swallowed.
Keep all plastic wrapping materials away from babies and children to avoid danger of
suffocation.
Once items are part or fully assembled, they are not returnable unless faulty.
Some items will be supplied with a wall fixing strap, which we recommend is used to
secure the item to the wall, to prevent a child from accidentally pulling furniture over.
Furniture can be dangerous if incorrectly installed. Assembly should be carried out by a
competent person. No liability will be accepted for damage or injury caused by
incorrectly installed or assembled furniture.
This item is not for outdoor use – unless stated otherwise.
From time to time check that there are no loose fittings on the unit, re-tighten when
necessary.
Two people may be required for the assembly of this product.
www.dunelm.com
3x130x36cm
41.7x30x13cm
12
12
12
12
Parts & Fittings for Anya Dining Bench
(30768711)

Note: Do not fully tighten until all
fittings are in position.
Step 1:
Step 2:
1AE
2
A
B
C
D
E
www.dunelm.com
B
C
D
A
B
B
A

www.dunelm.com
Wood care advice
Wood is a natural product and each piece is individual.
Strong direct sunlight can affect the colour dramatically, so try to avoid this as much as
possible, we also recommend that any ornaments, coasters and items placed on the
product are periodically moved around to allow the colour to mellow evenly.
As a natural product, wood is affected by temperature and humidity. We recommend that
you avoid placing the furniture directly in front of heat sources such as radiators or fires as
this can cause cracking or warping over time.
The colour will mellow over time and new items can vary in shade from items that you have
already purchased.
Uneven floors could give the impression that doors of wall units and wardrobes are out of
alignment. Be aware of this and compensate if necessary, by adjusting the hinges or
packing a corner to level the item. Please refer to the instructions, included with your
furniture, and adjust accordingly.
Always use matts and coasters to protect the surface when placing items on the furniture.
This will help to protect the finish from heat, liquids or items that might scratch your
furniture.
When placing furniture on a wooden or laminate floor, please ensure that the plastic or felt
protectors are securely fitted and in place.
Always lift your furniture into place, avoid dragging it across the floor as this can cause
damage to joints.
Only clean using a damp cloth and mild detergent, do not use bleach or abrasive cleaners.
Remove any spills immediately to avoid staining. Dust regularly with a soft lint free cloth or
duster.
If your furniture becomes stained, scratched, chipped or suffers other damage, we
recommend professional help is sought to restore it. Please contact our customer services
line for recommended agents.
If items are to be placed on the surface of your furniture and have rubber feet, it is advisable
to use mats to prevent marking.
From time to time check that there are no loose screws on this unit.
The use of abrasive polish or silicon-based polishes is not advised as these can affect the
polished finish and joints over time.
Always follow fitting instructions carefully and retain them for future use.