Dunelm XAVI SIDE TABLE User manual

INSTRUCTIONS
www.dunelm.com
50kg
30 MINS 2 PERSON ASSEMBLY MAX LOAD
XAVI SIDE TABLE
MEDIUM DIFFICULTY

www.dunelm.com
Thank you
Dear Customer
Thank you for purchasing your new piece of furniture from Dunelm. We put a lot of effort in the design and
construction of our products to ensure they set the standard for quality, durability and ease of assembly.
If for any reason you feel we haven’t lived up to the high standards we set ourselves, please don’t hesitate in
contacting us on 03451 656565 where our team will be very keen to understand what has gone wrong and,
more importantly, put it right.
The next step...
There is no need to feel daunted by the number of parts
and fittings in front of you, we have compiled this straight
forward, step-by-step guide to make sure that assembling
your furniture is as easy as 1, 2, 3.
Before you begin, we advise that you check that you have
everything you need to get started.
Top tip
Find a space to spread everything out across the floor
before you begin assembling the item. Lay each panel
down on a clean and level area, ideally in the room of
intended use, ensuring there is enough room to
manoeuvre around the item. It
is recommended that two people assemble this product
together. The full list of furniture parts, fixtures and fittings,
as well as the tools you will need for assembly can be found
on page 2 and 3 of this manual.
Top tip
Identify all of the fittings, make sure that you have them all
prepared and familiarise yourself with each component, to
make things easier when you are putting it all together.
Safety and care advice
IMPORTANT - The first step you need to take is to ensure
your safety! Please take the time to read and understand
these instructions before assembling your furniture.
Please keep these instructions for future reference.
Keep children and animals away from the assembly area.
This furniture contains small parts that could cause
choking if swallowed.
Keep all plastic wrapping materials away from babies and
children to avoid danger of suffocation.
Ensure that all packaging is disposed of carefully and
responsibly.
From time to time check that there are no loose fittings
on the unit, re-tighten when necessary.
Two people may be required for the assembly of this
product.
Once items are part or fully assembled they are not
returnable unless faulty.
This item is not for outdoor use –unless stated otherwise.
Some items will be supplied with a wall fixing strap, which
we recommend is used to secure the item
to the wall, to prevent a child from accidentally pulling
furniture over.Furniture can be dangerous if incorrectly
installed. Assembly should be carried out by a competent
person. No liability will be accepted for damage or injury
caused by incorrectly installed or assembled furniture.

www.dunelm.com
Component parts supplied
Ref Description Dimensions Visual Qty
1Bottom Leg
25.5x5x5cm
4
2Top Leg
41.5x6.5x5cm
4
3 1
1
4
5 1
Top
Connector 5x5x9.5cm
5x5x1cm
50x50x8cm
Wood Block

Fixtures and fittings supplied (actual size)
Ref Description Dimensions Visual Qty
4
16
Fixtures and fittings supplied (not to scale)
Ref Description Dimensions Visual Qty
C Spring washer M8 4
D Flat washer M8 4
E Allen key M5
1
4
Parts and fittings
BBolt M6x16mm
ABolt M8x25mm
GFootpad
FAllen key M4
1

www.dunelm.com
Exploded view

www.dunelm.com
Step 1:
Step 2:
Bx16
Fx1 G
Gx4
Attach footpad(G) to bottom leg(1), Fix bolt(B) to bottom leg(1) and top leg(2) ,Then tighten the bolt with allen
key(F) provided to 70% of the thread.
5mm
F
70%
Attach top leg(2) to connector(3) by inserting bolt into groove of connector.
3

www.dunelm.com
Step 3:
c
D
E
100%
Ax4
Cx4
Dx4
Ex1
Place top leg(2) upside down(After step2 assembly). Attach top leg(2) to underneath of glass top(5) and align the holes.
Fix through hole using bolt(A),spring washer(C), flat washer(D). Then tighten all bolts with allen key(E) (F) provided to
100% of the thread.
F

www.dunelm.com
Step 4:
Step 5:
4
Place the table on the ground and put wood block(4) on top of connector.
Attach bottom leg(1) to connector(3) by inserting bolt into groove of connector. Then tighten all bolts with allen key(F)
provided to 100% of the thread.

www.dunelm.com
Assembly instructions
500mm
600mm

www.dunelm.com
Glass care advice
Regular glass care advice
Do not use glass as a chopping board.
Do not use very hot or very cold items on the glass unless
adequate table mats are used to prevent such items coming
into direct contact with the furniture.
Do not strike the glass with hard or pointed items.
Do not use abrasive cleaners on the glass as these may scratch
and damage the glass.
To clean your item, please use a soft cloth slightly
dampened with water and wipe clean.
Then buff with a dry clean cloth. Use washing up
liquid if necessary.
If the glass is chipped or broken, stop using the
product and consult Dunelm.
Wood care advice
Wood care advice
Wood is a natural product and each piece is individual.
As a natural product, wood is affected by temperature and
humidity. We recommend that you avoid placing the
furniture directly in front of heat sources such as radiators or
fires as this can cause cracking or warping over time.
The colour will mellow over time and new items can vary in
shade from items that you have already purchased.
Strong direct sunlight can affect the colour dramatically, so
try to avoid this as much as possible, we also recommend that
any ornaments, coasters and items placed on the product are
periodically moved around to allow the colour to mellow
evenly.
Always use matts and coasters to protect the surface when
placing items on the furniture. This will help to protect the
finish from heat, liquids or items that might scratch your
furniture.
If items are to be placed on the surface of your furniture and
have rubber feet, it is advisable to use mats to prevent
marking.
Always lift your furniture into place, avoid dragging it across
the floor as this can cause damage to joints.
When placing furniture on a wooden or laminate floor, please
ensure that the plastic or felt protectors are securely fitted
and in place.
Only clean using a damp cloth and mild
detergent, do not use bleach or abrasive cleaners.
From time to time check that there are no loose
screws on this unit.
Remove any spills immediately to avoid staining.
Dust regularly with a soft lint free cloth or duster.
The use of abrasive polish or silicon based polishes
is not advised as these can affect the polished finish
and joints over time.
Uneven floors could give the impression that
doors of wall units and wardrobes are out of
alignment. Be aware of this and compensate if
necessary by adjusting the hinges or packing a
corner to level the item. Please refer to the
instructions, included with your furniture, and
adjust accordingly.
If your furniture becomes stained, scratched,
chipped or suffers other damage, we recommend
professional help is sought to restore it. Please
contact our customer services line for
recommended agents.
Always follow fitting instructions carefully and
retain them for future use.