DESCRIPTION
• Control volume levels or effects
pedals with exacting precision
• Patented Low Friction Band-Drive
for highly reliable action
• Fully adjustable rocker tension
DIRECTIONS
• We recommend placing the Volume
(XL) at the beginning of your effects
signal chain. Run a cable from your
guitar to the Volume (XL)’s INPUT
jack.
• Optional: Run a cable from the
TUNER output to a tuner. Signal
to tuner is active regardless of
rocker position.
VOLUME MODE (250 kΩPOT)
• Run a cable from the Volume (XL)’s
OUTPUT jack to your amplifier.
• With the pedal in full toe-down
position, set your guitar and amp’s
maximum desired volume level.
• Move the rocker pedal toward the
heel-down position to decrease
the volume.
• The output signal will be muted
when the rocker pedal reaches
full heel-down position.
DVP1XL VOLUME (XL) PEDAL
EXPRESSION MODE (10 kΩPOT)
• Run a stereo or TRS cable from the
Volume (XL)’s FX jack to your effect
pedal's expression jack.
• With the pedal in full toe-down
position, set the effect parameter
you want to control to the desired
maximum level.
• Optional: To set the effect
parameter’s minimum level, use
internal potentiometer toward the
front of the pedal (remove bottom
plate). Turn it clockwise to raise the
minimum level or counterclockwise
to lower it. Note: factory setting is
fully counterclockwise.
• Move the rocker pedal toward the
heel-down position to lower the
value of the effect parameter within
the range set by your effect pedal’s
control and the Volume (XL)’s
internal potentiometer.
• When the rocker is fully heel-down,
the effect parameter will be at
the minimum value as set by the
internal potentiometer.
• Optional: Use the internal blue push
switch to reverse the function of
heel and toe-down postions.
DUNLOP MANUFACTURING, INC | P.O. BOX 846 BENICIA, CA 94510 U.S.A. | 1-707-745-2722
CONTROLS
• OUTPUT jack for volume signal control
• FX output for effect parameter control
• TUNER jack for constant signal
to tuner
• INTERNAL 50 kΩPOT for setting
minimum heel-down value, wired
in series with expression pot
• INTERNAL SWITCH for reversing
foot/heel polarity
ADJUSTABLE TORQUE
To adjust rocker pedal torque, place
pedal in toe-down position. Insert a
1/4" flat blade screwdriver into torque
adjust screw located under heel-end
of rocker pedal. Turn clockwise to
increase resistance or counterclockwise
to decrease resistance.
POWER
The Volume (XL) is passive and does
not require a power source to operate.
PEDAL DIMENSIONS
Height 3" (76.2 mm)
Width 4.5" (114.3 mm)
Length 11.5"(292.1 mm)
Weight 4 lbs. (1.814 kg)
TM
