PROGRAMMING INSTRUCTION :
Select the range with the help of 2 slide
switches on the side panel. The selected
range can be seen in the windows on the
front panel.
Set the required time by gently rotating the
Front pot with suitable screw driver.
Apply rated voltage across A and A2
terminals.
The LED glows and the time starts.
After the set time the LED goes off and
relay contact changes from NC to NO.
Relay contacts remains in same position,
till power is interrupted.
HINTS ON CORRECT USAGE
Use proper gauge wires for connections.
Ensure all terminals are tightly screwed.
Source Voltage should not exceed
specified limits it will damage the unit
beyond repair.
Adjust the positions of slide switches
and Pot to get desired time.
CAUTION
Do not change the time range & set
time while the timer is in operation.
Switch off the power while changing the
time range and set time.
Application of voltage other than the
specified one will permanently damage
the timer.
Do not forcibly rotate the pot. It will
damage the timer.
DISPOSITION
Once the product life is over, you may send
back the unit to EAPL for disposition.
TROUBLE ANALYSIS
Unit not working.
Check power supply
(Rated supply should be applied).
CONTACT
Electronic Automation Pvt. Ltd
# 20, KHB Industrial area
Yelahanka
Bangalore -64
Ph
: +9 -80-2856756 /2 /42802345
www.eaplindia.com
Page 2 of 2
