Eartec EVADE CMod Series User manual

Safety
1. To prevent possible hearing damage, do not listen at high volume levels for long periods.
2. Risk of explosion if ba>ery is replaced by an incorrect type, dispose of ba>ery according to the
instruc@on.
3. Recycle your products
The WEEE logo (shown at right) appears on the product to indicate that this product must not be
disposed of or dumped with your other household wastes. You are liable to dispose of all your
electronic or electrical waste equipment by transpor@ng to an appropriate collec@on point for
recycling of such hazardous waste.
FCC Radia(on Exposure Statement: This equipment complies with FCC radia@on exposure limits set
forth for an uncontrolled
environment.
IC Warning:
This device complies with Industry Canada licence-exempt RSS standard(s). Opera@on is subject to
the following two condi@ons: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired opera@on of the device.
L'exploita@on est autorisée aux deux condi@ons suivantes: (1) l'appareil ne doit pas produire de
brouillage, et (2) l'u@lisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est suscep@ble d'en
IC Radia@on Exposure Statement:
This equipment complies with IC RSS-102 radia@on exposure limits set forth for an uncontrolled
environment. This device and its antenna(s) must not be co-located or opera@ng in conjunc@on with
any other antenna or transmi>er.
FCC No@ce
This device complies with Part 15 of FCC rules. Opera@on is subject to the following 2 condi@ons: (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired opera@on. Changes or modifica@ons not
expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
Warranty
Eartec items are warran-ed against defects in material and/or factory
workmanship for a set period from the date of purchase. Standard repairs due to
misuse or wear and tear, as well as replacement parts including but not limited to
ba=eries, padding, USB cable, etc. are excluded. Shipping to Eartec is at
customer’s expense, Eartec will pay for return ground shipping if the product
warranty applies to the repair. Call for details.
!"#$$#%&
Prior to returning your headset for warranty or service you must call Eartec for an
RA (return authoriza-on) number: 1.800.399.5994.
'(%()*+,!()-#.(
All repair work will be performed for the cost of replacement parts and return
shipping from the Eartec factory.
Service / Eartec
145 Dean Knauss Drive
Narraganse6, RI. 02882
www.eartec.com
1.800.399.5994
EVADE CMod Series
Communicate in Total Comfort
Light Industrial Wireless System
!"#!$$!%&'
(!)*+),-%#!'
Effec%ve range up to
1/2 mile.
.!-)'+%'$!*&'+)'
)/01&'!-)'Mic boom
swivels 270 degrees.
$/&1/2,'3-&&!)/!4'
Provide con%nuous 8 hr
opera%on and are field
replaceable.

IMPORTANT
/++,0%#12,3*)4(5,6/78,3021,9(,10)%(5,:;8<
1=,+#%4,1"(,.=))(2$=%5#%&,
>?6;@?,"(*52(12,A,B6=5C
456789'47:;7<='>'&<;?'+%':@@'<?A76'9:;B8C',-/%D
1. Turn ON each EVADE MAIN headset by pressing the power
buJon located above the volume controls. A flashing green
LED on the earcup confirms the headset is in search mode.
2. Select AC adapter or baJery, then power up The CMod by
rota%ng the ON/OFF/Volume dial clockwise. LED confirms
power is on.
3. Turn ON each EVADE Remote headset by pressing the power
buJon located above the volume controls.
4. Flashing LEDs change to solid green to indicate that
headsets have successfully connected.
487'EF@<98
Select the desired volume by slowly clicking the up or down
buJons. An audible tone reflects volume level. A double tone
indicates max volume.
!!!!!!!!"#$%&!'(!)*+,-!.!/+0%1!2%.1*%$!/+$2!$2%!34#15!
!!!!!!!!!!!!!!!!!!!.16)*$!*#),1!7%8%7!/+$2!8#7)9%!1+.7:
;$()*D=%
E(*52(1,/5F0213(%12
G*H()I
@"(,B6=5
&G8'#,FC':?C':@@'!E-H!'G8:C6876':;8'=FI8;8C'J5':'$A7GA<9'
(F@598;'J:K8;5'7G:7'IA@@'F=8;:78'LMN'GF<;6'IG8?'O<@@5'PG:;Q8CD
#G:;QA?Q
1. BaJeries are charged via the mul%-charger.
2. Insert the baJeries making sure the contacts are properly
aligned.
3. RED: Charging; GREEN: Fully Charged.
/?67:@@:RF?
1. The CMod: Slide baJery compartment open, insert baJery,
click closed.
2. To e ject b aJ ery press t he re l ea se buJon lo cated at the to p
of the compartment.
3. Insert baJery by snapping onto place.
$FI'/?CAP:7F;
A repe%%ve beep (every 20 seconds) indicates low power –
baJery should be charged or replaced. to turn off.
3:K8;5'#:;8
To p rese r ve o p)mum charge level remove ba 2ery from headsets
when not in use.
The CMod Battery Slot
Microphone mutes when
boom is in “UP” position.
Boom swivels so
headset can be worn on
left or right.
Position microphone one-finger
width from your mouth.
Speak into the front- indicated
by TALK.
HEADSET ON/OFF
VOLUME
UP / DOWN
#F?O8;8?P8',FC8
Each %me The CMod is turned on the default se`ng will be dual channel. Up to 8 headsets can
communicate privately on Ch 1 & Ch 2. Pressing the green conference buJon connects the channels to
link all 16 headsets (LED turns red).
4G<7'HFI?
Rotate The CMod on/off/vol dial un%l it clicks off. Press and hold power buJon on the EVADE headsets
for 4-5 seconds to turn off.
To p rese r ve o p)mum charge level remove ba 2ery from headsets whe n not in use.
;!<!32.0-%!=.>?
@!<!@.A%0B!',*%0$
3!<!C,!D!CE!F+.7
F!G!H%I.0.$%!D!3#9J+,%!H/+$>2
K!<!',$%07+,?!=.>?
L!<!M%.1*%$!=.>?
N!<!@%7$!37+I
M!<!O0#-0.99+,-!@)A#,*
AD
E
F
G
BH
Back
Expand system - Interlink two Conference Modules.
P: O#/%0!C"!J#$2!9#1)7%*:
Q: 3#,,%>$!/+$2!MF4'!>.J7%!8+.!+,$%07+,?!6.>?:
R: O0%**!C"K!H%I.0.$%D3#9J+,%!H/+$>2:
S: @#$2!TKF*!/+77!$)0,!0%15!+,1+>.U,-!3#,(%0%,>%!4#1%:
7%1()+#%4,;$D=%
C