Eartec CLIP User manual

Safety
1) To prevent possible hearing damage, do not listen at high volume levels for long periods.
2) Risk of explosion if battery is replaced by an incorrect type, dispose of battery according to
the instruction.
3) Recycle your products. The WEEE logo appears on the product to indicate that this
product must not be disposed of or dumped with your other household wastes. You are
liable to dispose of all your electronic or electrical waste equipment by transporting to an
appropriate collection point for recycling of such hazardous waste.
4) FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment.
5) IC Warning: This device complies with Industry Canada license-exempt RSS standards.
Operation is subject to the following two conditions: 1. This device may not cause
interference, and 2. This device must accept any interference including interference that may
cause undesired operation of the device.
6) IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation
exposure limits set forth for an uncontrolled environment. This device and its antenna must
not be co-located or operating in conjunction with any other antenna or transmitter.
7) FCC Notice: This device complies with Part 15 of FCC rules. Operation is subject to the
following 2 conditions: 1. This device may not cause harmful interference, and 2. This device
must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Warranty
Eartec items are warranted against defects in material and/or factory
workmanship for a set period from the date of purchase. Standard repairs due to
misuse or wear and tear, as well as replacement parts including but not limited to
batteries, padding, USB cable, etc. are excluded. Shipping to Eartec is at
customer’s expense, Eartec will pay for return ground shipping if the product
warranty applies to the repair. Call for details.
Shipping
Prior to returning your headset for warranty or service you must call Eartec for an
RA (return authorization) number: 1.800.399.5994.
General Service
All repair work will be performed for the cost of replacement parts and return
shipping from the Eartec factory.
Service / Eartec www.eartec.com
145 Dean Knauss Drive 1.800.399.5994
Narragansett, RI. 02882
The CLIP
Full Duplex Wireless System
Instruction Manual

The Master CLIP must be turned “ON”
to link all Remote CLIP.
Charging / Built-In Battery
1. Remove Neoprene Cover.
2. Insert CLIP into Multi-Charger.
3. Corresponding LED indicator:
RED=Charging,
GREEN=Full Charge
4. Run time -4 hours.
Operation
1) Identify the MASTER and power it ON.
2) Turn all REMOTE Clips ON.
3) Plug in lightweight headsets (if included).
4) Set listening volume level as desired.
Signal Strength Indicator
The CLIP provides hands free full duplex communication up to ¼ mile. A
continuous beep indicates loss of signal / operating range has been exceeded.
The Cyber Headset with lightweight back band
Microphone Mute Button
Volume up/down
Power button (center)
Multi-Port charger
Microphone Placement
For optimum performance place directly in front of,
and appx. 1/4 “ from mouth.
IN – Mic is Live, Transmit
OUT –Mic gain is paused
Back Band worn behind
& below hairline