East West Furniture AVT User manual

AVON TABLE
- 1 -
ASSEMBLY INSTRUCTIONS
SKU: AVT
Description
Dimension
:
AVON
TABLE
: W.42”xD.(42”/60”)xH.30”
Cube Size : 44.4”x44.4” x8” N : 74.8 LBS
(Top) G : 83.6 LBS
Cube Size : 24.4”x10.5” x9” N : 17.6 LBS
(Pedestal) G : 19.8 LBS
175 Southbelt Industrial
Dr
Houston, TX 77047
Email: [e-mail]

AVON TABLE
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability.
Please take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment.
Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call for us.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being
scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have the following parts:
NO Description Qty S etch NO Description Qty S etch
Top 1 B Pedestal
column 1
C Leg 4
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have all of the following hardware:
NO Description Qty S etch NO Description Qty S etch
1
Flat washer
(Φ8.5xΦ19mm)
12 2
Lock washer
(Φ8.5xΦ13mm)
12
3
Hexagon nut
(M8x13mm)
12 4
Wrench
(M13mm)
1
5
llen key
(4mm)
1

AVON TABLE
- 3 -
STEP 1
ttach Legs (C) to column (B) by using Nuts (3), and Washers (2) and (1). Tighten with Wrench (4) as
shown below.
STEP 2
Use the llen key (5) to loosen the bolts, and take off the plate underneath of the table top.
5
A
REMOVED UNSCREW
X6

AVON TABLE
- 4 -
STEP 3
Place the plate on top of the column (B), attach with washers (1), (2) and nuts (3). Tighten with the
Wrench (4) as shown below.
STEP 4
Carefully put the pedestal block on the bottom side of the table top, attach the top to plate
with bolts (from step 2) and tighten with the llen key (5)

AVON TABLE
- 5 -
STEP 5
Unlatch 2 end pieces of table top by the latches underneath table top. Pull the 2 ends of the
table top apart.
STEP 6
Unfold the butterfly leaf with the apron at both ends straightened up as shown on the Step 6.
Place flattened butterfly leaf at the center of the table. Then push two end pieces inward
making sure all pins & holes aligned. Latch them together by the 4 latches underneath table
top