Eaton PowerXL DG1 Series VFD User manual

PowerXL DG1 Series VFD Effective July 2014
Power Xpert in Control Quick Start Guide
Step 1 –Installation
Download the Power Xpert inControl Software with the One Installer found on the
www.eaton.com/dg1 software tab.
Step 2 –Connecting
Keypad Port: Using the PowerXL DG1 programming cable (Part Number DXG-
CBL-PCCABLE) connect from your computer USB port to the keypad port.
Ethernet Port: Using any standard CAT5 Ethernet cable connect from your
computer to the RJ45 Ethernet Port. Note: Your drive IP address will have to be
set up in the drive keypad parameters (Group P20.3) to match the IP address
structure in your computer before connecting.
Step 3 –Configuring Connection
Open Power Xpert inControl and double click on either the Modbus Serial (Keypad Port)
or Modbus TCP (Ethernet Port) on the right side in the Device Catalog (red). Once com-
plete, the device DTM should then show up in the Network View (blue).
If the Modbus Serial (Keypad Port) is selected the Communication Settings window will
come up which should be set to the following values.
Configuration Parameter
Setting
Port
Need to check in windows device properties for port
USB to RS485 adapter was installed at.
Parity*
Even
Data Bits*
8
Baud Rate*
38400
Stop Bits*
1
Transmission Mode*
RTU

MZ040012EN Power Xpert inControl Quick Start Guide
Effective July 2014
2 EATON CORPORATION www.eaton.com
Step 4 –Loading Device
In the Device Catalog (red), double click on the PowerXL DG1 drive, it will be added to
the Network View in (blue) under the communication DTM.
Next the Set Address window will appear and the communication address needs to be
set based on the below.
oModbus Serial (Keypad Port)
Configuration Parameter
Setting
Slave Address
18
oModbus TCP (Ethernet Port)
Configuration Parameter
Setting
IP Address*
XXX.XXX.XXX.XXX
* The IP address should be set via the keypad on the drive.
With the PowerXL DG1 drive selected, click the Go Online button. Then double click
on the drive to load device parameters, these will be shown in the main window
(green).
The PowerXL DG1 is now ready to be configured by the Power Xpert inControl
software.

MZ040012EN Power Xpert inControl Quick Start Guide
Effective July 2014
Additional Help
In the US or Canada: please contact the Technical Resource Center at 1-877-ETN-CARE
or 1-877-326-2273 option 2, option 6.
All other supporting documentation is located on the Eaton web site at www.eaton.com/Drives
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122 USA
Eaton.com
© 2014 Eaton
All Rights Reserved
Printed in USA
Publication No. MZ040012EN
July 2014
Eaton is a registered trademark
of Eaton Corporation.
All other trademarks are property
of their respective owners