Eaton 9395 UPS (225–300 kVA) Single Feed Kit S164201722 Rev 2 www.eaton.com/powerquality
1
Eaton 9395 UPS (225–300 kVA) Single-Feed Kit Installation
NOTE Refer to the applicable installation and operation manual supplied with the UPS during installation.
WARNING
Installation should be performed only by qualified personnel.
To install the single-feed kit:
1. If not already accomplished, remove one top screw and two bottom screws
securing the UPS left front panel (refer to the applicable Eaton 9395 UPS manual
for panel location). Lift the panel straight up to remove it from the panel hanger
bracket at the top of the cabinet.
2. If not already accomplished,remove the screws securing the internal safety
shield panel and remove the panel to gain access to the rectifier and bypass input
terminals. Retain the hardware for later use.
3. Using hardware from the single-feed kit (see Table 1), install the single-feed
jumper cables from the kit between the rectifier input terminals and the input
bypass input terminals (see Figure 1). Tighten the bolts to the torque values
listed in Table 2.
4. Return to the applicable Eaton 9395 UPS manual to complete the wiring.
Table 1. Supplied Terminal Hardware
Part Size Quantity Terminals Used On Eaton Part Number
Jumper Cable N/A 6 Rectifier and Bypass Input 152602507
(wire kit with 6 cables)
Bolt, Grade 5 M12 45 mm 6Rectifier and Bypass Input 180190078-113
Flat Washer M12 12 Rectifier and Bypass Input 180500036-120
Conical Washer M12 6 Rectifier and Bypass Input 180500037-120
Nut M12 6 Rectifier and Bypass Input 180200001-07
Table 2. Single-Feed Power Cable Terminations
Terminal Function Terminal Function Bus Landing Tightening Torque
Nm (lb ft) Bolt Size
Rectifier Input
E1 Phase A 1 – 1 bolt mounting 76 (56) M12
E2 Phase B 1 – 1 bolt mounting 76 (56) M12
E3 Phase C 1 – 1 bolt mounting 76 (56) M12
Bypass Input
E6 Phase A 1 – 1 bolt mounting 76 (56) M12
E7 Phase B 1 – 1 bolt mounting 76 (56) M12
E8 Phase C 1 – 1 bolt mounting 76 (56) M12
