Edelbrock 8125 User manual

©2002 Edelbrock Corporation
Brochure No. 63-0088 Rev. 4/02
Catalog #8125
Stainless Steel Fuel Line
for Small Block Ford
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new stainless steel fuel line. If you have any questions or
problems, please call our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard
Time or e-mail us at edelbrock.edelbrock.com.
NOTE: This kit is designed for use with Edelbrock fuel pump part #1725 with the addition of the bottom feed plate kit,
part #1797.
INSTALLATION PROCEDURE
1. The pump body when installed on the engine should be clocked with the inlet towards the front of the car as shown
below.
2. Refer to the hose installation tip illustrations below.
3. Apply light coat of oil to threads of each fitting except pipe thread end of adapter that installs into fuel pump bottom
plate.
4. Apply pipe sealant tape or wet sealant to pipe thread on adapter fitting before installing fitting into pump bottom
plate.
5. The braided stainless steel hose must not make any contact with electrical wires. If the steel braided hose is routed
near the alternator or any other electrical device, attention must be taken to ensure that all of the insulating boots
and retainers, etc., are in place.
6. Tighten all connections and check each connection for leaks.
Pump Inlet Position Front of Vehicle
Fuel Tank
Fuel Inlet
Carb Side
Fuel Outlet
Use both
Plugs
Provided
Avoid installing the hose in a twisted position.
This can weaken your assembly and loosen
fitting connections when under pressure.
Right
Wrong
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line 1-800-416-8628
E-Mail: [email protected]
Hose Installation Tip
PostScript Picture
(Edelbrock B/W Logo.eps)