Edelbrock Russell 672500 User manual

© 2006 Edelbrock Corporation
Brochure No. 63-672500
Catalog #672500
Rev. 6/06 - BC/mc
Catalog #672500
Russell DOT Brake Hose Kit
for 2007 GM Suburban 1500 2WD
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Brake Line Kit. If you have any questions, please call
our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard Time or e-mail us
at [email protected].
INSTALLATION PROCEDURE
IIMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.
Doing so may require removing the master cylinder from the vehicle for bench bleeding. Also, use care when handling
brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).
1. Remove factory brake hoses, noting routing. Cap hard lines and calipers.
2. Using factory banjo bolt and supplied crush washers, install banjo end of Russell front hose onto caliper oriented
up and in with bend towards front
(See Fig. 1).
3. Install inboard hose end through hole in factory bracket and retain with supplied E-clip. Attach hardline to hose end.
4. Locate hose and ABS wire to upper a-arm using supplied clamp, locknut, bolt, and spacer. Insert bolt through clamp
on ABS wire and thread through factory-tapped hole in a-arm. Install spacer and clamp on hose onto end of bolt
under a-arm and secure with locknut
(See Fig. 2 & Fig. 3) .
5. Install Russell rear hoses (Inner and Outer as marked) using factory routing. Retain hose ends in factory brackets
with supplied E-clips.
6. Check hose clearance throughout entire steering and suspension travel range.
7. Bleed the system and check for leaks while applying pressure.
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: 800-416-8628
Office: 310-781-2222
E-Mail: [email protected]
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.
Fig 1 Fig 2 Fig 3