EIBENSTOCK KBM 50P User manual

KBM 50P

KBM 50P

GUIDE
BED
GUIDE
BAR
SPINDLE
SLEEVE

KBM 50P
KBM 50P
YES
18
2. OVERALL DIAMENSIONS
Stroke (mm) 133

2
3
3. ASSEMBLY
Cutter Assembly
1. The install/remove cutter
A. Raise up the drill motor to its highest position.
B. Ensure grub screws are loosened.
C. Insert cutter into drill spindle with the two flats of the cutter aligned with grub
screws (Fig No.4 & 5). Make sure the center pin is inserted into
the cutter.
NOTE : Cutter should be fully placed into drill spindle.
C. Tighten set screws with M4 Allen key provided.
D. Reverse procedure to remove cutter.
!

Do not remove cutter unless slug is removed. Slug may eject unexpectedly.
Avoid contact with cutter tips. Periodically inspect the cutter tips for loose or
damaged tips.

MAGNET ON

Fig. No. 6 Fig. No. 7
7
5. PRECAUTIONS OF USE
6

Fig. No. 8 Fig. No. 9 Fig. No. 10
Fig. No. 11
8
9
11
12
10
6. OPERATION INSTRUCTIONS
Fig. No. 12

Fig. No. 13
7. MAINTENANCE AND TROUBLE SHOOTING
13

4 & 5)
6 & 7)

8. ELECTRICAL CONNECTION DIAGRAM