Eickemeyer HAICO TELGTE II User manual

INSTALLATION GUIDE
HAICO TELGTE II
EQUINE OPERATING TABLE
Item no. 608750
TELEPHONE [phone]
www.eickemeyer.com

2
INSTALLATION GUIDE HAICO TELGTE II EQUINE OPERATING TABLE
T [phone] | F [phone] | [e-mail] | www.eickemeyer.com
Installations of the new table ….. about one hour work as follows:
Installing the Table
Before you start working with the surgery table make the following installation works.
1. Install the fuse to its place (located in the rear end of the table).
Tools: a small screwdriver (3 to 5 mm wide)
2. Install the head part of the table to its place.
Tools: 6mm allen key, 13mm spanner, two 17mm spanners
3. Install the charger on the wall.
Tools: 10mm drill (type depends on the wall material), cross type screwdriver
4. Install the equipment stand on the wall.
Tools: 10 mm drill (type depends on the wall material),10mm spanner, srewdriver (5 to 10 mm wide)
5. Charge the battery before start using the table.
Installing the Fuse
Installing the Head Support
Hasp screws to be installed Screw installation directionThe screws

3
INSTALLATION GUIDE HAICO TELGTE II EQUINE OPERATING TABLE
T [phone] | F [phone] | [e-mail] | www.eickemeyer.com
Using the Battery Charger
This automatic charger is designed for 90 to 270 V AC and 50 to 60 Hz.
In order to start the charge the battery terminal voltage must be over 1 V.
In case the terminal voltage is under 1 V the battery may be in short and it should be replaced.
Telgte series tables Pro3 tables with magnet plug Note the hanging way
The built in micro controller controls the charging process.
Yellow LED on
Charge in progress
Max power: For max power ON – disconnect and connect again the wall plug
Time: 0 – 12h
Both LEDs on
Battery almost full
14.4 V charge
Time: 4h
Green LED on
Charge ready
Maintenance charge 13.7V
No time limit
Attention!
• Keep the magnetic contacts clean from metal crumbs or connection between the charger and the battery may
be cut off.
• As a safety measure, the charger should be mounted on a wall at a height of about 1.5 m.
The LEDs here

4
INSTALLATION GUIDE HAICO TELGTE II EQUINE OPERATING TABLE
T [phone] | F [phone] | [e-mail] | www.eickemeyer.com
Equipment Stand
Install the equipment stand on a wall and keep the equipment in order as shown in the photo.

INSTALLATION GUIDE HAICO TELGTE II EQUINE OPERATING TABLE
NOTES
5T [phone] | F [phone] | [e-mail] | www.eickemeyer.com

INSTALLATION GUIDE HAICO TELGTE II EQUINE OPERATING TABLE
NOTES
6 T [phone] | F [phone] | [e-mail] | www.eickemeyer.com

INSTALLATION GUIDE HAICO TELGTE II EQUINE OPERATING TABLE
NOTES
7T [phone] | F [phone] | [e-mail] | www.eickemeyer.com

GERMANY
EICKEMEYER KG
Eltastraße 8
78532 Tuttlingen
T [phone]
F [phone]
[e-mail]
www.eickemeyer.de
ITALY
EICKEMEYER S.R.L.
Via G. Verdi 8
65015 Montesilvano (PE)
T [phone]
F [phone]
[e-mail]
www.eickemeyer.it
UNITED KINGDOM
EICKEMEYER Ltd.
3 Windmill Business Village
Brooklands Close
Sunbury-on-Thames
Surrey, TW16 7DY
T [phone]
[e-mail]
www.eickemeyer.co.uk
SWITZERLAND
EICKEMEYER AG
Sandgrube 29
9050 Appenzell
T [phone]
F [phone]
[e-mail]
www.eickemeyer.ch
DENMARK
EICKEMEYER ApS
Solbakken 26, Hammelev
6500 Vojens
T [phone]
[e-mail]
www.eickemeyer.dk
CANADA
EICKEMEYER Inc.
617 Douro Street, Suite #205
Stratford, Ont. Canada
N5A 0B5
T [phone]
F [phone]
[e-mail]
www.eickemeyercanada.ca
POLAND
EICKEMEYER Sp. z o.o.
Al. Jana Pawła II 27
00-867 Warszawa
T [phone]
F [phone]
[e-mail]
www.eickemeyer.pl
NETHERLANDS
EICKEMEYER B.V.
Bellweg 44
4104 BJ Culemborg
T [phone]
[e-mail]
www.eickemeyer.nl