ekwb EK-Vardar X3M 120ER User manual

USER GUIDE
EK-Vardar
X3M 120ER

This product is intended for installation by expert users only. Please
consult with a qualified technician. Improper installation may result
in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products or
their installation. The following instructions are subject to change
without notice. Please, read the manual carefully before beginning
with the installation process.

- 3 -
TABLE OF CONTENT
INSTALLING THE FAN ON THE RADIATOR 4
INSTALLING THE FAN DIRECTLY 4
REPLACING THE RUBBER CORNERS (DAMPERS) 5
REPLACING THE RUBBER CORNERS (DAMPERS) 6
SUPPORT AND SERVICE 7
SOCIAL MEDIA 7

- 4 -
INSTALLING THE FAN ON THE RADIATOR
Take the four encosed UNC 6-32 x 10 (10 mm long) screws for each
fan and screw them in. The number of enclosed screws depends
on the radiator model. Use the enclosed Allen key to tighten the
screws in a clockwise direction. Don’t use excessive force while
tightening the screws.
UNC 6-32 x 10 Screw
INSTALLING THE FAN DIRECTLY
Using the enclosed mounting screws and thumb nuts you can mount
the EK-Vardar X3M fan directly to your chassis or any other standard
fan mounting location.
EK-Vardar X3M 120ER
UNC
6-32 x 10
Thumb
Nut

- 5 -
REPLACING THE RUBBER CORNERS (DAMPERS)
STEP 1
First unscrew pre-installed M4 screws and thumb nuts using Allen
key (as shown on the photo). Carefully take off the rubber corner and
save the screws and nuts for later use.
STEP 1
STEP 2
STEP 2
New dampers need to be secured with M4 screws and Thumb nuts.
Don’t use excessive force while tightening the screws.
M4 Screw
M4 Thumb Nut

CONNECTING THE FANS
STEP 1
To connect the fans you might need EK-Cable Y splitter.
Connect the female connectors from the fans with male connectors
on the fan splitter cable.
- 6 -
STEP 2
Connect the female EK-Cable Y splitter connector to the male
connector header located on the motherboard. Always use CPU-
dedicated fan headers if possible.
Always use CPU fan header. On majority of motherboards
these headers usually offer best PWM regulation.
STEP 2
Fan Header
STEP 1

For assistance please contact:
http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SUPPORT AND SERVICE
SOCIAL MEDIA
discord.gg/zesFRJB